UG-851 Datasheet, PDF (3/15 Pages) Analog Devices – EVAL-AD7606SDZ/EVAL-AD7607SDZ/EVAL-AD7608SDZ User Guide

EVAL-AD7606SDZ/EVAL-AD7607SDZ/EVAL-AD7608SDZ User Guide
UG-851
QUICK START GUIDE
Follow these steps to quickly evaluate the AD7606/AD7606-6/
AD7606-4/AD7607/AD7608 ADC. For detailed instructions,
see the subsequent sections.
1. Install the evaluation software from the AD7606/AD7606-6/
AD7606-4/AD7607/AD7608 product pages or from the
included CD. Ensure that the EVAL-SDP-CB1Z SDP
board is disconnected from the USB port of the PC while
installing the software. (The PC may need to be restarted
after the installation.)
2. Ensure that the various link options are configured as
outlined in Table 3.
3. Connect the EVAL-SDP-CB1Z SDP board to the
evaluation board as shown in Figure 2. Screw the two
boards together using the enclosed nylon screw/nut kit
to ensure that the boards connect firmly together.
4. Connect a 5 V power supply to J1 and ensure LK1 is in
Position A.
5. Connect the EVAL-SDP-CB1Z SDP board to the PC via
the USB cable. Choose to automatically search for the
drivers for the SDP board if prompted by the operating
system.
6. Launch the evaluation software from the Analog Devices
subfolder in the Programs menu.
7. Connect an input signal via V1 to V8.
J1
LK1
V1 TO V8
Figure 2. Evaluation Board (Left) Connected to the SDP Board (Right)
Rev. 0 | Page 3 of 15