UG-851 Datasheet, PDF (10/15 Pages) Analog Devices – EVAL-AD7606SDZ/EVAL-AD7607SDZ/EVAL-AD7608SDZ User Guide

UG-851
EVAL-AD7606SDZ/EVAL-AD7607SDZ/EVAL-AD7608SDZ User Guide
WAVEFORM CAPTURE TAB
The Waveform tab, as shown in Figure 14, is used for waveform
capture.
The waveform analysis reports the amplitudes recorded from
the captured signal as well as the frequency of the signal tone.
The analysis report is generated for the ADC channel selected
via the menu down the right hand side (Label 1 in Figure 14).
At the bottom right of the graph are the zoom options. These
allow you to zoom in and out to get a closer look at a sample.
The Waveform Analysis section (Label 2 in Figure 14), which is
located beneath the waveform graph, contains information about
the samples taken; for example, minimum/maximum position
or velocity, the spread, the standard deviation, and the mean.
The waveform graph displays the information for all eight input
channels or as many channels as desired. Eight buttons located
to the right hand side of the graph, labeled ADC 1 ON/OFF to
ADC 8 ON/OFF are used to select which channel’s data is
displayed (Label 1 in Figure 14). An indicator, located to the
right of the graph (Label 3 in Figure 14), shows what color
graph represents each channel when the data from several
channels is displayed.
Data Capture Display
Four tabs display the conversion data in different formats:
Waveform, Histogram, FFT, and Summary.
The tools shown in Figure 13 allow user control of the different
chart displays within the four tabs.
123
1. USED FOR CONTROLLING
THE CURSOR IF PRESENT.
2. USED FOR ZOOMING IN AND OUT.
3. USED FOR PANNING.
Figure 13. Chart Tools
1
3
2
Figure 14. Waveform Tab
Rev. 0 | Page 10 of 15