UG-277 Datasheet, PDF (3/24 Pages) Analog Devices – SDP-B Controller Board

SDP User Guide
PRODUCT OVERVIEW
The SDP-B board features
• Analog Devices ADSP-BF527 Blackfin processor
• Core performance up to 600 MHz
• 208-ball CSP-BGA package
• 24 MHz CLKIN oscillator
• 5 Mb of internal RAM memory
• 32 Mb flash memory
• Numonyx M29W320EB or
• Numonyx M25P32
• SDRAM memory
• Micron MT48LC16M16A2P-6A - 16 Mb x 16 bits
(256 Mb/32 MB)
• 3 × 120-pin small foot print connectors
• Hirose FX8-120P-SV1(91), 120-pin header
• Blackfin processor peripherals exposed
• SPI
• SPORT
• TWI/I²C
• GPIO
• PPI
• Asynchronous parallel
• Timers
For more information, go to http://www.analog.com/sdp.
TECHNICAL OR CUSTOMER SUPPORT
You can reach Analog Devices customer support in the
following ways:
• Visit the SDP website at
http://www.analog.com/sdp
• Email processor questions to
• [e-mail] (worldwide support)
• [e-mail] (Europe support)
• [e-mail] (China support)
• Phone questions to
1-800-ANALOGD
• Contact your Analog Devices local sales office or
authorized distributor.
• Send questions by mail to
Analog Devices, Inc.
Three Technology Way
P.O. Box 9106
Norwood, MA 02062-9106
USA
UG-277
PRODUCT INFORMATION
Product information can be obtained from the Analog Devices
website.
Analog Devices Web Site
The Analog Devices website, www.analog.com, provides
information about a broad range of products—analog
integrated circuits, amplifiers, converters, and digital signal
processors.
Note that MyAnalog.com is a free feature of the Analog Devices
website that allows customization of a web page to display only
the latest information about products of interest to you. You can
choose to receive weekly email notifications containing updates
to the web pages that meet your interests, including
documentation errata against all documents. MyAnalog.com
provides access to books, application notes, data sheets, code
examples, and more.
Visit MyAnalog.com to sign up. If you are a registered user, just
log on. Your user name is your email address.
REGULATORY COMPLIANCE
The EVAL-SDP-CB1Z is designed to be used solely in a labor-
atory environment. The board is not intended for use as a
consumer end product or as a portion of a consumer end
product. The board is an open system design, which does not
include a shielded enclosure and therefore may cause interfer-
ence to other electrical devices in close proximity. This board
should not be used in or near any medical equipment or
RF devices. Store unused boards in the protective shipping
package.
The EVAL-SDP-CB1Z board has been certified to comply with
the essential requirements of the European EMC directive
89/36/EC amended by 93/68/EEC and therefore carries the
CE mark.
Rev. B | Page 3 of 24