EVAL-AD7403FMCZ Datasheet, PDF (3/20 Pages) Analog Devices – Full featured evaluation board

EVAL-AD7403FMCZ User Guide
GETTING STARTED
QUICK START STEPS
Follow these steps to quickly evaluate the AD7403 ADC:
1. Install the evaluation software from the AD7403 product
page or from the CD included in the EVAL-AD7403FMCZ
evaluation board kit. Ensure that the EVAL-SDP-CH1Z
board is disconnected from the USB port of the PC while
installing the software. (The PC may need to be restarted
after the installation)
2. Ensure that the various link options are configured as
outlined in Table 2.
3. Connect the EVAL-SDP-CH1Z board to the evaluation
board as shown in Figure 2.
UG-683
4. Connect the EVAL-SDP-CH1Z board to the PC via the
USB cable. For Windows® XP, you may need to search for
the EVAL-SDP-CH1Z drivers. Choose to automatically
search for the drivers for the EVAL-SDP-CH1Z board if
prompted by the operating system.
5. Power up the EVAL-SDP-CH1Z by inserting the 12 V dc
barrel jack (included with the EVAL-SDP-CH1Z) into the
barrel connector labeled +12V_VIN on the EVAL-SDP-CH1Z.
6. Launch the evaluation software from the Analog Devices
subfolder in the Programs menu.
7. Connect an input signal via the VIN+, J1 connector.
Figure 2. EVAL-AD7403FMCZ Evaluation Board (Left) Connected to the EVAL-SDP-CH1Z Board (Right)
Rev. 0 | Page 3 of 20