ACE25C320G Datasheet, PDF (28/37 Pages) ACE Technology Co., LTD. – Uniform SECTOR Dual and Quad Serial Flash

ACE25C320G
Uniform SECTOR Dual and Quad Serial Flash
Read Security Registers (48H)
The Read Security Registers command is similar to Fast Read command. The command is followed
by a 3-byte address (A23-A0) and a dummy byte, each bit being latched-in during the rising edge of
SCLK. Then the memory content, at that address, is shifted out on SO, each bit being shifted out, at a
Max frequency fC, during the falling edge of SCLK. The first byte addressed can be at any location.
The address is automatically incremented to the next higher address after each byte of data is shifted
out. Once the A9-A0 address reaches the last byte of the register (Byte 3FFH), it will reset to 000H,
the command is completed by driving CS# high.
Address
A23-A16
A15-A8
A7-A0
Security Registers 1
00H
01H
Byte Address
Security Registers 2
00H
02H
Byte Address
Security Registers 3
00H
03H
Byte Address
Figure27. Read Security Registers command Sequence Diagram
Write Enable for Volatile Status Register (50h)
The non-volatile Status Register bits described on page 40 can also be written to as volatile bits.
During power up reset, the non-volatile Status Register bits are copied to a volatile version of the
Status Register that is used during device operation. This gives more flexibility to change the system
configuration and memory protection schemes quickly without waiting for the typical non-volatile bit
write cycles or affecting the endurance of the Status Register non-volatile bits. To write the volatile
version of the Status Register bits, the Write Enable for Volatile Status Register (50h) command
must be issued prior to each Write Status Registers (01h) command. Write Enable for Volatile Status
Register command (Figure 29) will not set the Write Enable Latch (WEL) bit, it is only valid for the
next following Write Status Registers command, to change the volatile Status Register bit values.
VER 1.5 28