AAT8640 Datasheet, PDF (22/25 Pages) Advanced Analog Technology, Inc. – ONE-CELL LI-ION BATTERY PROTECTION IC

Advanced Analog Technology, Inc.
PACKAGE DIMENSION (CONT.)
AAT8640 Series
DIMENSIONS IN MILLIMETERS DEMINSIONS IN INCHES
SYMBOLS
MIN
TYP
MAX
MIN TYP MAX
A
1.05
1.20
1.35
0.041 0.047 0.053
A1
0.05
0.10
0.15
0.002 0.004 0.006
A2
1.00
1.10
1.20
0.039 0.043 0.047
b
0.25
------
0.50
0.010 ------ 0.020
b1
0.25
0.40
0.45
0.010 0.016 0.018
c
0.08
------
0.20
0.003 ------ 0.008
c1
0.08
0.11
0.15
0.003 0.004 0.006
D
2.70
2.90
3.00
0.106 0.114 0.118
E
2.60
2.80
3.00
0.102 0.110 0.118
E1
1.50
1.60
1.70
0.059 0.063 0.067
L
0.35
0.45
0.55
0.014 0.018 0.022
L1
0.60 REF
0.024 REF
e
0.95 BSC
0.037 BSC
e1
1.90 BSC
0.075 BSC
θ
0^ο
5^ο
10 ^ο
0^ο
5^ο
10 ^ο
θ1
3^ο
5^ο
7^ο
3^ο
5^ο
7^ο
θ2
6^ο
8^ο
10 ^ο
6^ο
8^ο
10 ^ο
NOTE:
1. DIMENSION D DOES NOT INCLUDE MOLD FLASH, PROTRUSIONS OR GATE BURRS.
MOLD FLASH, PROTRUSIONS OR GATE BURRS SHALL NOT EXCEED 0.20 MILLIMETERS PER SIDE.
2. DIMENSION E1 DOES NOT INCLUDE INTERLEAD FLASH OR PROTRUSION.
INTERLEAD FLASH OR PROTRUSION SHALL NOT EXCEED 0.20MILLIMETERS PER SIDE.
3. THE PACKAGE TOP MAY BE SAMLLER THAN PACKAGE BOTTOM.
DIMENSION D AND E1 ARE DETERMINED AT THE OUTERMOST EXTREMES OF THE PLASTIC BODY
EXCLUSIVE OF MOLD FLASH, TIE BAR BURRS, INTERLEAD FLASH AND GATE BURRS, BUT
INCLUDING ANY MISMATCH BETWEEN THE TOP AND BOTTOM OF THE MOLDED BODY.
4. THE SECTION B-B APPLY TO THE FLAT SECTION OF THE LEAD BETWEEN 0.08 MILLIMETERES AND
0.15 MILLIMETERS FROM THE LEAD TIP
5. LEAD FRAME MATERIAL: EFTEC-64T 1/2H OR H.
– 台灣類比科技股份有限公司 –
– Advanced Analog Technology, Inc. –
Page 22 of 25
V2.0