M02046-15 Datasheet, PDF (9/27 Pages) M/A-COM Technology Solutions, Inc. – 3.3 5V Limiting Amplifier for Applications from 100 Mbps to 1.25 Gbps

M02046-15
3.3/5V Limiting Amplifier for Applications from 100 Mbps to 1.25 Gbps
Rev V4
2.0 Pin Definitions
Table 2-1.
QSOP Pin#
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Pin Descriptions
Name
Function
ST_SET
V_CC3
GND
Loss of signal threshold setting input. Connect a 1% resistor between this pin and V_CC3 (pin 2) to set loss of signal threshold.
Power supply input for 3.3V applications or the output of the internally regulated 3.3V voltage when V_CC = 5V. Connect
directly to supply for 3.3V applications (internal regulator not in use). Do not connect to power supply if V_CC = 5V.
Ground.
DINP
DINN
NC
Non-inverting data input. Internally terminated with 50Ω to V_TT (see Figure 3-2).
Inverting data input. Internally terminated with 50Ω to V_TT (see Figure 3-2).
No Connect. Leave Floating.
V_CC3
Power supply input for 3.3V applications or the output of the internally regulated 3.3V voltage when V_CC = 5V. Connect
directly to supply for 3.3V applications (internal regulator not in use). Do not connect to power supply if V_CC = 5V.
JAM
Output disable. When high, data outputs are disabled (with non-inverting output held high and inverting output held low).
Connect to LOS output to disable outputs with loss of signal. Outputs are enabled when JAM is low or floating. Internal 150
kΩ resistor to ground.
LOS
Loss of signal output. Goes high when input signal falls below threshold set by ST_SET. This output is an open collector TTL
with internal 80 kΩ pull-up resistor to V_CC. Leave floating if not used.
ST
Signal detect output. Goes high when input signal amplitude is above threshold set by ST_SET. In M02046-15, this output is
an open collector TTL with internal 80 kΩ pull-up resistor to V_CC; In M02046-25, this output is PECL. Leave floating if not
used.
GND
Ground.
PECLN
Inverting data output (PECL).
PECLP
Non-inverting data output (PECL).
V_CC
Power supply. Connect to either +5V or +3.3V.
NC
No Connect. Leave Floating.
I_REF
Internal reference current for the LOS threshold. Must be connected to ground through a 12.1 kΩ 1% resistor.
9
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
http://www.macom.com/support