M02046-15 Datasheet, PDF (16/27 Pages) M/A-COM Technology Solutions, Inc. – 3.3 5V Limiting Amplifier for Applications from 100 Mbps to 1.25 Gbps

M02046-15
3.3/5V Limiting Amplifier for Applications from 100 Mbps to 1.25 Gbps
Rev V4
Note that ST_SET can be left open if the loss of signal detector function is not required. In this case LOS would be
low.
Figure 3-6. STset Input
V_CC3
V_CC
R_ST
ST_SET
V_STSET
3.3.5
JAM Function
When asserted, the active high power down (JAM) pin forces the outputs to a logic “one” state. This ensures that
no data is propagated through the system. The loss of signal detection circuit can be used to automatically force
the data outputs to a high state when the input signal falls below the threshold. The function is normally used to
allow data to propagate only when the signal is above the user's bit-error-rate requirement. It therefore inhibits the
data outputs toggling due to noise when there is no signal present (“squelch”).
In order to implement this function, LOS should be connected to the JAM pin shown in Figure 3-7, thus forcing the
data outputs to a logic “one” state when the signal falls below the threshold.
Figure 3-7. JAM Input
V_CC
JAM
55 kΩ
100 kΩ
16
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
http://www.macom.com/support