Z86L98ZEM Datasheet, PDF (8/10 Pages) Zilog, Inc. – Z8 In-Circuit Emulator

Z86L98 ZEM
Z8 In-Circuit Emulator
6
5. There is no flag if the debugger.ld file is older than the Assembly files when
connecting or downloading codes to the emulator.
6. External DATA memory fill takes at least 50 secs per 1K of data memory.
This slow-down avoids time-out errors and loss of communication. Note that
using the External Data memory window is valid only when it exists on the
target application board.
7. Does not support saving debugger set-up/windows.
8. Does not support short cut or hot keys for the Debugger.
9. Does not support stepping into an include file.
10. The dissasembly window-up arrow scroll does not work yet.
Work around: Drag the vertical scroll bar.
Note: _{Please refer to specific Customer Procurement Specifications}
(CPS) or Product Information (PI) documents for specific
Limitations and Precautions for each ICEBOX/Emulator.
All Z8 Emulators
1. Do not put a breakpoint at addresses after a STOP instruction. This causes
the program counter to continue at that location after Stop-Mode Recovery.
2. Single-stepping into a Halt instruction causes an ICEBOX ÒFatal ErrorÓ
message appear on the screen. The ICE chip must be reset, either by the
/Reset pin on the target board or by resetting the whole ICEBOX by pressing
the emulator MASTER RESET button at the back of the emulator.
3. Clicking on the STOP button does not always halt the ICEBOX execution. If
the application goes into Stop Mode or Halt Mode, the only way to halt the
emulator execution is by doing a Stop- Mode Recovery (as defined by the
user program). The application can also be reset by using the emulator
MASTER RESET button; however, this reset the whole ICEBOX.
4. RC oscillator emulation is not supported.
5. When the software enters STOP mode and the STOP debugging button
control button is pressed, any SMR source on the application board is
activated, and the emulator jumps back to address 000C hex, which is
PS002601-Z8X0300