Z86E02SL1925 Datasheet, PDF (8/18 Pages) Zilog, Inc. – CMOS Z8 OTP MICROCONTROLLER

Z86E02 SL1925
CMOS Z8® OTP Microcontroller
DC ELECTRICAL CHARACTERISTICS (Continued)
Zilog
T_A = 0°C to _Typical
+70°C
Note 4
Sym Parameter
V_CC [4] _{Min Max @ 25°C Units Conditions}
Notes
I_CC1 Standby Current
(Low Noise Mode)
I_CC2 Standby Current
I_ALL Auto Latch Low
Current
I_ALH Auto Latch High
Current
3.5V
5.5V
3.5V
5.5V
3.5V
5.5V
3.5V
5.5V
3.5V
5.5V
3.5V
5.5V
1.2
0.4
mA HALT mode V_IN = 0V,V_CC
7
@ 1 MHz
1.6
0.9
mA HALT mode V_IN = 0V,V_CC
7
@ 1 MHz
1.5
0.5
mA HALT mode V_IN = 0V,V_CC
7
@ 2 MHz
1.9
1.0
mA HALT mode V_IN = 0V,V_CC
7
@ 2 MHz
2.0
0.8
mA HALT mode V_IN = 0V,V_CC
7
@ 4 MHz
2.4
0.3
mA HALT mode V_IN = 0V,V_CC
7
@ 4 MHz
10.0
1.0
µA STOP mode V_IN = 0V, V_CC
7,8
WDT is not Running
10.0
1.0
µA STOP mode V_IN = 0V, V_CC
7,8
WDT is not Running
12.0
3.0
µA 0V < V_IN < V_CC
6
32
16
µA 0V < V_IN < V_CC
6
–8.0 –1.5
µA 0V < V_IN < V_CC
6
–16.0 –8.0
µA 0V < V_IN < V_CC
6
Notes:
1. Port 2 and Port 0 only.
2. V_SS = 0V = GND.
3. The device operates down to V_RST of the specified frequency for V_RST. The minimum operational V_CC is determined on the value
of the voltage V_RST at the ambient temperature. The V_RST increases as the temperature decreases.
4. V_CC = 4.5V to 5.5V, typical values measured at V_CC = 5.0V.
5. Standard Mode (not Low EMI mode).
6. Autolatches are enabled.
7. All outputs unloaded and all inputs are at V_CC or V_SS level.
8. If analog comparator is selected, then the comparator inputs must be at V_CC level.
8
PRELIMINARY
CP97DZ83501