Z86E02SL1925 Datasheet, PDF (5/18 Pages) Zilog, Inc. – CMOS Z8 OTP MICROCONTROLLER

Zilog
Z86E02 SL1925
CMOS Z8® OTP Microcontroller
ABSOLUTE MAXIMUM RATINGS
Stresses greater than those listed under Absolute Maxi- dissipation should not exceed 462 mW for the package.
mum Ratings may cause permanent damage to the de- Power dissipation is calculated as follows:
1
vice. This is a stress rating only; functional operation of the
device at any condition above those indicated in the oper-
ational sections of these specifications is not implied. Ex-
posure to absolute maximum rating conditions for an ex-
tended period may affect device reliability. Total power
Total Power Dissipation =
V_DD x [I_DD - (sum of I_OH)]
+ sum of [(V_DD - V_OH) x I_OH]
+ sum of (V_0L x I_0L)
Parameter
Min
Max
Ambient Temperature under Bias
Storage Temperature
Voltage on any Pin with Respect to V_SS
Voltage on V_DD Pin with Respect to V_SS
Voltage on Pins 7, 8, 9, 10 with Respect to V_SS
Total Power Dissipation
Maximum Allowable Current out of V_SS
Maximum Allowable Current into V_DD
Maximum Allowable Current into an Input Pin
Maximum Allowable Current into an Open-Drain Pin
Maximum Allowable Output Current Sinked by Any I/O Pin
Maximum Allowable Output Current Sourced by Any I/O Pin
–40
–65
–0.7
–0.3
–0.6
–600
–600
+105
+150
+12
+7
V_DD+1
462
240
240
+600
+600
20
20
Notes:
[1] This applies to all pins except where otherwise noted. Maximum current into pin must be ±600 µA.
[2] There is no input protection diode from pin to V (not applicable to EPROM Mode).
DD
[3] This excludes Pin 6 and Pin 7.
[4] Device pin is not at an output Low state.
Units
C
C
V
V
V
mW
mA
mA
µA
µA
mA
mA
Note
1
2
3
4
STANDARD TEST CONDITIONS
The characteristics listed below apply for standard test
conditions as noted. All voltages are referenced to
Ground. Positive current flows into the referenced pin (Fig-
ure 5).
From Output
Under Test
150 pF
Figure 5. Test Load Diagram
CP97DZ83501
PRELIMINARY
5