Z86E02SL1925 Datasheet, PDF (11/18 Pages) Zilog, Inc. – CMOS Z8 OTP MICROCONTROLLER

Zilog
Z86E02 SL1925
CMOS Z8® OTP Microcontroller
Sym Parameter
V_CC [4]
T_A = -40°C to
+105°C
Min
Max
Typical
Note 4
@ 25°C
Units
Conditions
1 Notes
I_CC1 Standby Current
4.5V
(Low Noise Mode)
1.6
0.9
mA HALT mode V_IN = 0V, V_CC @ 7
1 MHz
5.5V
1.6
0.9
mA HALT mode V_IN = 0V, V_CC @ 7
1 MHz
4.5V
1.9
1
mA HALT mode V_IN = 0V, V_CC @ 7
2 MHz
5.5V
1.9
1
mA HALT mode V_IN = 0V, V_CC @ 7
2 MHz
I_CC2 Standby Current
4.5V
20
1.0
µA STOP mode V_IN = 0V, V_CC
7,8
WDT is not Running
5.5V
20
1.0
µA STOP mode V_IN = 0V, V_CC
7,8
WDT is not Running
ALL
Auto Latch Low
4.5V
40
16
µA 0V < V_IN < V_CC
6
Current
5.5V
40
16
µA 0V < V_IN < V_CC
6
I_ALH Auto Latch High
4.5V
–20.0
–8.0
µA 0V < V_IN < V_CC
6
Current
5.5V
–20.0
–8.0
µA 0V < V_IN < V_CC
6
Notes:
1. Port 2 and Port 0 only.
2. V_SS = 0V = GND.
3. The device operates down to V_RST of the specified frequency for V_RST. The minimum operational V_CC is determined on the value
of the voltage V_RST at the ambient temperature. The V_RST increases as the temperature decreases.
4. V_CC = 4.5V to 5.5V, typical values measured at V_CC = 5.0V.
5. Standard Mode (not Low EMI mode).
6. Autolatches are enabled.
7. All outputs unloaded and all inputs are at V_CC or V_SS level.
8. If analog comparator is selected, then the comparator inputs must be at V_CC level.
CP97DZ83501
PRELIMINARY
11