X24641 Datasheet, PDF (9/13 Pages) Xicor Inc. – 400 KHz 2-Wire Serial E 2 PROM

X24641
ABSOLUTE MAXIMUM RATINGS*
Temperature under Bias
X24641.......................................–65°C to +135°C
Storage Temperature ........................–65°C to +150°C
Voltage on any Pin with
Respect to V_SS.................................... –1V to +7V
D.C. Output Current ..............................................5mA
Lead Temperature
(Soldering, 10 seconds) .............................. 300°C
*COMMENT
Stresses above those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device.
This is a stress rating only and the functional operation
of the device at these or any other conditions above
those indicated in the operational sections of this
specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may
affect device reliability.
RECOMMENDED OPERATING CONDITIONS
Temperature
Commercial
Industrial
Min.
0°C
–40°C
D.C. OPERATING CHARACTERISTICS
Max.
+70°C
+85°C
7026 FRM T04
Supply Voltage
X24641
X24641–2.5
X24641–1.8
Limits
4.5V to 5.5V
2.5V to 5.5V
1.8V to 3.6V
7026 FRM T05
Limits
Symbol
Parameter
Min.
Max. Units
Test Conditions
I_CC1
I_CC2
I_SB1(1)
I_SB2(1)
I_LI
I_LO
V_lL(2)
V_IH(2)
V_OL
V_hys(3)
V_CC Supply Current (Read)
V_CC Supply Current
(Write)
V_CC Standby Current
V_CC Standby Current
Input Leakage Current
Output Leakage Current
Input LOW Voltage
Input HIGH Voltage
Output LOW Voltage
Hysteresis of Schmitt
Trigger Inputs
–0.5
V_CC x 0.7
V_CC x 0.05
1
3
3
1
10
10
V_CC x 0.3
V_CC + 0.5
0.4
mA SCL = V_CC X 0.1/V_CC X 0.9 Levels
mA ^{@ 400KHz, SDA = Open, All Other}
Inputs = V_SS or V_CC – 0.3V
µA SCL = SDA = V_CC – 0.3V,
All Other Inputs = V_SS or V_CC – 0.3V,
V_CC = 5V ± 10%
µA SCL = SDA = V_CC – 0.1V,
All Other Inputs = V_SS or V_CC – 0.1V,
V_CC = 1.8V
µA V_IN = V_SS to V_CC
µA V_OUT = V_SS to V_CC
V
V
V I_OL = 3mA
V
CAPACITANCE T_A = +25°C, f = 1MHz, V_CC = 5V
7026 FRM T06.1
Symbol
C_I/O(3)
C_IN(3)
Parameter
Input/Output Capacitance (SDA)
Input Capacitance (S₀, S₁, S₂, SCL,WP)
Notes: (1) Must perform a stop command prior to measurement.
(2) V_IL min. and V_IH max. are for reference only and are not 100% tested.
(3) This parameter is periodically sampled and not 100% tested.
Max.
8
6
Units
pF
pF
Test Conditions
V_I/O = 0V
V_IN = 0V
7026 FRM T07
9