X24C02 Datasheet, PDF (6/16 Pages) Xicor Inc. – Serial E2PROM

X24C02
Page Write
The X24C02 is capable of a four byte page write opera-
tion. It is initiated in the same manner as the byte write
operation, but instead of terminating the write cycle after
the first data word is transferred, the master can transmit
up to three more words. After the receipt of each word,
the X24C02 will respond with an acknowledge.
After the receipt of each word, the two low order address
bits are internally incremented by one. The high order six
bits of the address remain constant. If the master should
transmit more than four words prior to generating the
stop condition, the address counter will “roll over” and
the previously written data will be overwritten. As with
the byte write operation, all inputs are disabled until
completion of the internal write cycle. Refer to Figure 6
for the address, acknowledge and data transfer se-
quence.
Acknowledge Polling
The disabling of the inputs, during the internal write
operation, can be used to take advantage of the typical
5 ms write cycle time. Once the stop condition is issued
to indicate the end of the host’s write operation the
X24C02 initiates the internal write cycle. ACK polling
can be initiated immediately. This involves issuing the
start condition followed by the slave address for a write
operation. If the X24C02 is still busy with the write
operation no ACK will be returned. If the X24C02 has
completed the write operation an ACK will be returned
and the master can then proceed with the next read or
write operation.
READ OPERATIONS
Read operations are initiated in the same manner as
write operations with the exception that the R/W bit of the
slave address is set to a one. There are three basic read
operations: current address read, random read and
sequential read.
It should be noted that the ninth clock cycle of the read
operation is not a “don’t care.” To terminate a read
operation, the master must either issue a stop condition
during the ninth cycle or hold SDA HIGH during the ninth
clock cycle and then issue a stop condition.
Flow 1. ACK Polling Sequence
WRITE OPERATION
COMPLETED
ENTER ACK POLLING
ISSUE
START
ISSUE SLAVE
ADDRESS AND R/W = 0
ACK
NO
RETURNED?
YES
NEXT
OPERATION
NO
A WRITE?
YES
ISSUE BYTE
ADDRESS
ISSUE STOP
ISSUE STOP
PROCEED
PROCEED
3838 FHD F12
6