X9250 Datasheet, PDF (4/21 Pages) Xicor Inc. – Quad Digitally Controlled Potentiometers (XDCP)

X9250
Figure 1. Detailed Potentiometer Block Diagram
(One of Four Arrays)
Serial Data Path
Serial
From Interface
Circuitry
Bus
Input
C
Register 0
Register 1
o
u
8
8
Parallel
Bus
Input
n
t
e
r
Register 2
If WCR = 00[H] then V_W/R_W = V_L/R_L
If WCR = FF[H] then V_W/R_W = V_H/R_H
Register 3
Wiper
D
Counter
e
Register
c
(WCR)
o
d
e
UP/DN
Inc/Dec
Logic
UP/DN
Modified SCK _CLK
V_H/R_H
V_L/R_L
V_W/R_W
Write in Process
The contents of the Data Registers are saved to
nonvolatile memory when the CS pin goes from LOW
to HIGH after a complete write sequence is received
by the device. The progress of this internal write
operation can be monitored by a write in process bit
(WIP). The WIP bit is read with a read status
command.
Figure 2. Identification Byte Format
Device Type
Identifier
0 1 0 1 0 0 A1 A0
Device Address
INSTRUCTIONS
Identification (ID) Byte
The first byte sent to the X9250 from the host,
following a CS going HIGH to LOW, is called the
Identification byte. The most significant four bits of the
slave address are a device type identifier, for the
X9250 this is fixed as 0101[B] (refer to Figure 2).
The two least significant bits in the ID byte select one
of four devices on the bus. The physical device
address is defined by the state of the A₀-A₁ input pins.
The X9250 compares the serial data stream with the
address input state; a successful compare of both
address bits is required for the X9250 to successfully
continue the command sequence. The A₀–A₁ inputs
can be actively driven by CMOS input signals or tied to
V_CC or V_SS.
The remaining two bits in the slave byte must be set to 0.
Instruction Byte
The next byte sent to the X9250 contains the
instruction and register pointer information. The four
most significant bits are the instruction. The next four
bits point to one of the four pots and, when applicable,
they point to one of four associated registers. The
format is shown below in Figure 3.
Figure 3. Instruction Byte Format
Register
Select
I3 I2 I1 I0 R1 R0 P1 P0
Instructions
Pot Select
REV 1.1.5 1/31/03
www.xicor.com
Characteristics subject to change without notice. 4 of 21