X24645 Datasheet, PDF (11/18 Pages) Xicor Inc. – Advanced 2-Wire Serial E 2 PROM with Block Lock TM Protection

X24645
ABSOLUTE MAXIMUM RATINGS*
Temperature under Bias
X24645.......................................–65°C to +135°C
Storage Temperature ........................–65°C to +150°C
Voltage on any Pin with
Respect to V_SS.................................... –1V to +7V
D.C. Output Current ..............................................5mA
Lead Temperature
(Soldering, 10 seconds) .............................. 300°C
*COMMENT
Stresses above those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device.
This is a stress rating only and the functional operation
of the device at these or any other conditions above
those indicated in the operational sections of this
specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may
affect device reliability.
RECOMMENDED OPERATING CONDITIONS
Temperature
Min.
Max.
Commercial
0°C
+70°C
Industrial
–40°C
+85°C
Military
–55°C
+125°C
2783 FRM T04
D.C. OPERATING CHARACTERISTICS
Supply Voltage
X24645
X24645-2.7
Limits
4.5V to 5.5V
2.7V to 5.5V
2783 FRM T05
Limits
Symbol
I_CC1
I_CC2
Parameter
V_CC Supply Current (Read)
V_CC Supply Current (Write)
I_SB1(1)
V_CC Standby Current
Min.
I_SB2(1)
V_CC Standby Current
I_LI
I_LO
V_lL(2)
V_IH(2)
V_OL
Input Leakage Current
Output Leakage Current
Input LOW Voltage
Input HIGH Voltage
Output LOW Voltage
–1
V_CC x 0.7
CAPACITANCE T_A = +25°C, f = 1MHz, V_CC = 5V
Max.
1
3
50
1
10
10
V_CC x 0.3
V_CC + 0.5
0.4
Units
Test Conditions
mA SCL = V_CC X 0.1/V_CC X 0.9 Levels
mA
@ 100KHz, SDA = Open, All Other
Inputs = V_SS or V_CC – 0.3V
µA SCL = SDA = V_CC, All Other
Inputs = V_SS or V_CC – 0.3V,
V_CC = 5V ± 10%
µA SCL = SDA = V_CC, All Other
Inputs = V_SS or V_CC – 0.3V,
V_CC = 2.7V
µA V_IN = V_SS to V_CC
µA V_OUT = V_SS to V_CC
V
V
V I_OL = 3mA, V_CC = 4.5V
2783 FRM T06.2
Symbol
C_I/O(3)
C_IN(3)
Parameter
Input/Output Capacitance (SDA)
Input Capacitance (S₁, S₂, SCL)
Notes: (1) Must perform a stop command prior to measurement.
(2) V_IL min. and V_IH max. are for reference only and are not 100% tested.
(3) This parameter is periodically sampled and not 100% tested.
Max.
8
6
Units
pF
pF
Test Conditions
V_I/O = 0V
V_IN = 0V
2783 FRM T07.1
11