X28C64 Datasheet, PDF (10/25 Pages) Xicor Inc. – 5 Volt, Byte Alterable E2PROM

X28C64
ABSOLUTE MAXIMUM RATINGS*
Temperature under Bias
X28C64 ........................................ –10°C to +85°C
X28C64I, X28C64M ................... –65°C to +135°C
Storage Temperature ....................... –65°C to +150°C
Voltage on any Pin with
Respect to V_SS ....................................... –1V to +7V
D.C. Output Current ............................................. 5mA
Lead Temperature
(Soldering, 10 seconds) .............................. 300°C
*COMMENT
Stresses above those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device.
This is a stress rating only and the functional operation of
the device at these or any other conditions above those
indicated in the operational sections of this specification is
not implied. Exposure to absolute maximum rating condi-
tions for extended periods may affect device reliability.
RECOMMENDED OPERATING CONDITIONS
Temperature
Min.
Max.
Supply Voltage
Limits
Commercial
0°C
+70°C
X28C64
5V ±10%
Industrial
–40°C
+85°C
3853 PGM T03.1
Military
–55°C
+125°C
3853 PGM T02.1
D.C. OPERATING CHARACTERISTICS (Over the recommended operating conditions, unless otherwise specified)
Symbol
Parameter
ICC
VCC Current (Active)
(TTL Inputs)
Min.
Limits
Typ.⁽¹⁾
30
Max. Units
60
mA
I_SB1 V_CC Current (Standby)
(TTL Inputs)
ISB2 VCC Current (Standby)
(CMOS Inputs)
1
2
mA
100
200
µA
ILI
Input Leakage Current
I_LO
Output Leakage Current
VlL(2) Input LOW Voltage
–1
VIH(2) Input HIGH Voltage
2
V_OL Output LOW Voltage
VOH Output HIGH Voltage
2.4
10
µA
10
µA
0.8
V
VCC + 1 V
0.4
V
V
Notes: (1) Typical values are for T_A = 25°C and nominal supply voltage and are not tested.
(2) V_IL min. and V_IH max. are for reference only and are not tested.
Test Conditions
CE = OE = VIL, WE = VIH, All
I/O’s = Open, Address Inputs =
0.4V/2.4V Levels @ f = 5MHz
CE = V_IH, OE = V_IL
All I/O’s = Open, Other Inputs = V_IH
CE = WE = VCC – 0.3V
All I/O’s = Open,
Other Inputs = Don’t Care
VIN = VSS to VCC
V_OUT = V_SS to V_CC, CE = V_IH
I_OL = 2.1mA
IOH = –400µA
3853 PGM T04.2
10