WM8718 Datasheet, PDF (7/27 Pages) Wolfson Microelectronics plc – 24 BIT DIFFERENTIAL STEREO DAC WITH VOLUME CONTROL

WM8718
Production Data
Test Conditions
AVDD = 5V, DVDD = 3.3V, AGND, DGND = 0V, TA = +25^oC, fs = 48kHz, MCLK = 256fs unless otherwise stated.
PARAMETER
SYMBOL TEST CONDITIONS
MIN
TYP
MAX
Analogue Output Levels
Differential Output level
Load = 10kΩ, 0dBFS
2.0
Load = 10kΩ, 0dBFS,
1.32
(AVDD = 3.3V)
Gain mismatch
±1
channel-to-channel
Minimum resistance load
To midrail or a.c.
1
coupled
To midrail or a.c.
600
coupled
(AVDD = 3.3V)
Maximum capacitance load
5V or 3.3V
100
Output d.c. level
(AVDD-
GND)/2
Power On Reset (POR)
POR threshold
2.0
UNIT
VRMS
VRMS
%FSR
kΩ
Ω
pF
V
V
Notes:
1. Ratio of output level with 1kHz full scale input, to the output level with all ZEROS into the digital input, over a 20Hz to
20kHz bandwidth.
2. All performance measurements done with 20kHz low pass filter, and where noted an A-weight filter. Failure to use such a
filter will result in higher THD+N and lower SNR and Dynamic Range readings than are found in the Electrical
Characteristics. The low pass filter removes out of band noise; although it is not audible it may affect dynamic specification
values.
3. VMID decoupled with 10uF and 0.1uF capacitors (smaller values may result in reduced performance).
TERMINOLOGY
1. Signal-to-noise ratio (dB) - SNR is a measure of the difference in level between the full-scale output and the output with a
ZERO signal applied. (No Auto-ZERO or Automute function is employed in achieving these results).
2. Dynamic range (dB) - DNR is a measure of the difference between the highest and lowest portions of a signal. Normally a
THD+N measurement at 60dB below full scale. The measured signal is then corrected by adding the 60dB to it. (e.g.
THD+N @ -60dB= -32dB, DR= 92dB).
3. THD+N (dB) - THD+N is a ratio, of the rms values, of (Noise + Distortion)/Signal.
4. Stop band attenuation (dB) - Is the degree to which the frequency spectrum is attenuated (outside audio band).
5. Channel Separation (dB) - Also known as Cross Talk. This is a measure of the amount one channel is isolated from the
other. Normally measured by sending a full-scale signal down one channel and measuring the other.
6. Pass-Band Ripple – Any variation of the frequency response in the pass-band region.
w
PD Rev 4.1 March 2004
7