WM8580_07_12 Datasheet, PDF (21/97 Pages) Wolfson Microelectronics plc – Multichannel CODEC with S/PDIF Transceiver

Production Data
WM8580
REGISTER READBACK
The WM8580 allows readback of certain registers in 2-wire mode, with data output on the SDO pin.
As in 3-wire mode, there are two methods of reading back data: continuous and non-continuous
readback. Continuous readback is set by writing to the Readback Control register (see Table 9) to
set READEN and CONTREAD to 1, and to set the READMUX bits to select the register to be read
back. The status of this register can then be readback using the protocol shown in Figure 10.
Figure 10 2-Wire Continuous Readback
If CONTREAD is set to zero, the user can read back directly from the register by writing to the
register address, to which the device will respond with data. The protocol for this system is shown in
Figure 11.
Figure 11 2-Wire Non-Continuous Readback
SOFTWARE REGISTER RESET
Writing to register R53 will cause a register reset, resetting all register bits to their default values.
REGISTER
BIT
ADDRESS
R53
8:0
RESET
35h
Table 11 Software Reset
LABEL
RESET
DEFAULT
DESCRIPTION
n/a
Writing any data value to this register
will apply a reset to the device
registers.
w
PD Rev 4.3 August 2007
21