W25Q16V Datasheet, PDF (44/60 Pages) Winbond – 16M-BIT SERIAL FLASH MEMORY WITH DUAL AND QUAD SPI

W25Q16V
10.2.27 JEDEC ID (9Fh)
For compatibility reasons, the W25Q16 provides several instructions to electronically determine the
identity of the device. The Read JEDEC ID instruction is compatible with the JEDEC standard for SPI
compatible serial memories that was adopted in 2003. The instruction is initiated by driving the /CS pin
low and shifting the instruction code “9Fh”. The JEDEC assigned Manufacturer ID byte for Winbond
(EFh) and two Device ID bytes, Memory Type (ID15-ID8) and Capacity (ID7-ID0) are then shifted out on
the falling edge of CLK with most significant bit (MSB) first as shown in figure 28. For memory type and
capacity values refer to Manufacturer and Device Identification table.
Figure 28. Read JEDEC ID
- 44 -