W9751G8KB Datasheet, PDF (39/87 Pages) Winbond – 16M x 4 BANKS 꼌 8 BIT DDR2 SDRAM

W9751G8KB
9.7 Capacitance
SYM.
PARAMETER
CCK Input Capacitance , CLK and CLK
CDCK Input Capacitance delta , CLK and CLK
CI input Capacitance, all other input-only pins
CDI Input Capacitance delta, all other input-only pins
Input/output Capacitance, DQ, DM, DQS,
CIO _{DQS ,RDQS, RDQS}
Input/output Capacitance delta, DQ, DM, DQS,
CDIO _{DQS ,RDQS, RDQS}
MIN.
1.0

1.0

2.5

MAX.
2.0
0.25
2.0
0.25
3.5
0.5
UNIT
pF
pF
pF
pF
pF
pF
9.8 Leakage and Output Buffer Characteristics
SYM.
PARAMETER
Input Leakage Current
IIL
(0V ≤ VIN ≤ VDD)
Output Leakage Current
IOL _{(Output disabled, 0V ≤ VOUT ≤ VDDQ)}
VOH Minimum Required Output Pull-up
VOL Maximum Required Output Pull-down
VOTR Output Timing Measurement Reference Level
IOH(dc) Output Minimum Source DC Current
MIN.
-2
MAX.
2
-5
5
VTT + 0.603

0.5 x VDDQ
-13.4

VTT - 0.603


UNIT
µA
µA
V
V
V
mA
NOTES
1
2
3
4, 6
IOL(dc) Output Minimum Sink DC Current
13.4

mA
5, 6
Notes:
1. All other pins not under test = 0 V.
2. DQ, DQS, DQS , RDQS, RDQS are disabled and ODT is turned off.
3. The VDDQ of the device under test is referenced.
4. VDDQ = 1.7 V; VOUT = 1.42 V. (VOUT - VDDQ)/IOH must be less than 21 Ω for values of VOUT between VDDQ and VDDQ -
0.28V.
5. VDDQ = 1.7 V; VOUT = 0.28V. VOUT/IOL must be less than 21 Ω for values of VOUT between 0 V and 0.28V.
6. The values of IOH(dc) and IOL(dc) are based on the conditions given in Notes 3 and 4. They are used to test drive current
capability to ensure VIHmin plus a noise margin and VILmax minus a noise margin are delivered to an SSTL_18 receiver.
- 39 -
Publication Release Date: Feb. 15, 2012
Revision A01