W25X10 Datasheet, PDF (31/45 Pages) Winbond – 1M-BIT, 2M-BIT, 4M-BIT AND 8M-BIT SERIAL FLASH MEMORY WITH 4KB SECTORS AND DUAL OUTPUT SPI

W25X10, W25X20, W25X40, W25X80
11. ELECTRICAL CHARACTERISTICS (PRELIMINARY) ⁽⁴⁾
11.1 Absolute Maximum Ratings ⁽¹⁾
PARAMETERS
Supply Voltage
Voltage Applied to Any Pin
Storage Temperature
Lead Temperature
Electrostatic Discharge Voltage
SYMBOL
VCC
VIO
TSTG
TLEAD
VESD
CONDITIONS
Relative to Ground
Human Body Model⁽³⁾
RANGE
–0.6 to +4.0
–0.6 to VCC +0.4
–65 to +150
See Note ⁽²⁾
–2000 to +2000
UNIT
V
V
°C
°C
V
Notes:
1. This device has been designed and tested for the specified operation ranges. Proper operation
outside of these levels is not guaranteed. Exposure beyond absolute maximum ratings (listed
above) may cause permanent damage.
2. Compliant with JEDEC Standard J-STD-20C for small body Sn-Pb or Pb-free (Green) assembly
and the European directive on restrictions on hazardous substances (RoHS) 2002/95/EU.
3. JEDEC Std JESD22-A114A (C1=100 pF, R1=1500 ohms, R2=500 ohms).
4. See preliminary designation at the end of this datasheet.
11.2 Operating Ranges
PARAMETER
SYMBOL CONDITIONS
Supply Voltage⁽¹⁾
Ambient Temperature,
Operating
VCC
TA
F_R = 50MHz, fR = 33MHz
F_R0 = 70MHz, fR = 33MHz
F_R1 = 75MHz, fR = 33MHz
Commercial ⁽²⁾
Industrial
SPEC
MIN
MAX
2.7
3.6
3.0
3.6
3.0
3.6
0
+70
–40
+85
UNIT
V
°C
Note:
1.
2.
VCC voltage during Read can operate across the min and max range but should not exceed ±10% of the
programming (erase/write) voltage.
Commercial temperature only applies to Fast Read (F_R0 & F_R1) and 100K cycles endurance for 4K byte sectors .
Industrial temperature applies to all other parameters.
- 31 -
Publication Release Date: September 22, 2006
Preliminary - Revision I