WBP Datasheet, PDF (5/6 Pages) Vishay Siliconix – High voltage, current, and temperature range

www.vishay.com
WBP
Vishay Dale
PERFORMANCE
TEST
CONDITIONS OF TEST
Thermal shock ⁽¹⁾
-40 °C to + 85 °C, 500 cycles, 30 min at each extreme
High temperature exposure
+115 °C for 1000 h
High temperature operation
1000 h at +115 °C, 20 A at 1.5 h "ON", 0.5 h "OFF"
Low temperature operation
Biased humidity
1000 h at -40 °C, 20 A at 1.5 h "ON", 0.5 h "OFF
+85 °C, 85% RH, 1000 h ⁽²⁾
Mechanical shock
100 g’s for 6 ms, 5 pulses
Vibration
Frequency varied 10 Hz to 2000 Hz in 1 min, 3 directions, 12 h
Moisture resistance
MIL-STD-202, method 106, 0 % power, 7b not required
Jump start test
26 V, 1 min overvoltage jump start simulation
Reverse polarity test
-13.5 V, 2 min reverse polarity jump start simulation
Over voltage test
18 V, 60 min overvoltage simulation
State change waveform test
State change susceptibility (on / off)
Ground path inductance sensitivity
State change susceptibility (on / off) due to ground path inductance
Notes
• All test are completed on a pass-fail basis, judged by compliance with the datasheet specifications
(1) _{250 cycles unpowered, 250 powered}
(2) _{Circuit powered}
Revision: 05-Jan-17
5
Document Number: 30194
For technical questions, contact: [e-mail]
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000