DG604_11 Datasheet, PDF (4/12 Pages) Vishay Siliconix – 1.0 pC Charge Injection, 100 pA Leakage, 4-Channel Multiplexer

DG604
Vishay Siliconix
SPECIFICATIONS FOR SINGLE SUPPLY
Parameter
Analog Switch
Symbol
Test Conditions
Unless Otherwise Specified
V+ = 5 V, V- = 0 V
V_{IN A0, A1 and ENABLE} = 2 V, 0.8 V^a
Temp.^b
Typ.^c
- 40 °C to 125 °C - 40 °C to 85 °C
Min.^d Max.^d Min.^d Max.^d Unit
Analog Signal Range^e
V_ANALOG
Full
5
5
V
On-Resistance
On-Resistance Match
R_DS(on)
R_ON
I_S = 1 mA, V_D = + 3.5 V
I_S = 1 mA, V_D = + 3.5 V
Room 120
Full
Room 3
Full
170
170
250
200

5
5
12
10
Switch Off Leakage Current
(for 14 pin TSSOP)
I_S(off)
I_D(off)
Room ± 0.01 - 0.1 0.1 - 0.1 0.1
V+ = 5.5 V, V- = 0 V
Full
- 18
18 - 0.5 0.5
V_D = 1 V/4.5 V, V_S = 4.5 V/1 V _{Room ± 0.01 - 0.1 0.1 - 0.1 0.1}
Full
- 18
18 - 0.5 0.5
Channel On Leakage Current
(for 14 pin TSSOP)
Switch Off
Leakage Current
(for 16 pin miniQFN)
I_D(on)
I_S(off)
I_D(off)
V+ = 5.5 V, V- = 0 V
Room ± 0.01 - 0.1 0.1 - 0.1 0.1
V_S = V_D = 1 V/4.5 V
Full
- 18
18 - 0.5 0.5
Room ± 0.01 - 1
1
-1
1 ^nA
V+ = 5.5 V, V- = - 5.5 V
Full
- 18
18
-2
2
V_D = 1 V/4.5 V, V_S = 4.5 V/1 V _{Room ± 0.01 - 1}
1
-1
1
Full
- 18
18
-2
2
Channel On
Leakage Current
(for 16 pin miniQFN)
I_D(on)
V+ = 5.5 V, V- = 0 V,
V_S = V_D = 1 V/4.5 V
Room ± 0.01 - 1
1
-1
1
Full
- 18
18
-2
2
Digital Control
Input Current, V_IN Low
I_L
Input Current, V_IN High
I_H
V_{IN A0, A1 and ENABLE}
Under Test = 0.8 V
V_{IN A0, A1 and ENABLE}
Under Test = 2 V
Full 0.005 - 0.1
Full 0.005 - 0.1
0.1 - 0.1 0.1
µA
0.1 - 0.1 0.1
Input Capacitance
C_IN
f = 1 MHz
Room 4.3
pF
Dynamic Characteristics
Transition Time
Enable Turn-On Time
Enable Turn-Off Time
t_TRANS
Room 36
Full
t_ON(EN)
V_S(CLOSE) = 3 V, V_S(OPEN) = 0 V,
R_L = 300 , C_L = 35 pF
Room
Full
30
t_OFF(EN)
Room 17
Full
75
75
120
95
70
70
102
80
ns
47
47
88
63
Break-Before-Make-Time
t_BMM
Room 23
Full
5
5
Charge Injection
Off-Isolation^e
Crosstalk^e
Bandwidth^e
Total Harmonic Distortion
Source Off Capacitance^e
Drain Off Capacitance^e
Channel On Capacitance^e
Power Supplies
Q
OIRR
X_TALK
BW
THD
C_S(off)
C_D(off)
C_D(on)
C_L = 1 nF, R_GEN = 0 , V_GEN = 0 V
f = 10 MHz, R_L = 50 , C_L = 5 pF
R_L = 50 
Signal = 1 V_RMS, 20 Hz to 20 kHz,
R_L = 600 
Full
Room
Room
Room
Room
f = 1 MHz
Room
0.15
- 58
- 81
330
0.009
3.1
11.6
16.2
pC
dB
MHz
%
pF
Power Supply Current
I+
Room 0.001
0.5
0.5
Full
1
1
Negative Supply Current
I-
V_IN = 0 V, or V+
Room - 0.001 - 0.5
Full
-1
- 0.5
-1
µA
Ground Current
I_GND
Room - 0.001 - 0.5
Full
-1
- 0.5
-1
www.vishay.com
Document Number: 69934
4
S11-1429-Rev. C, 18-Jul-11
This document is subject to change without notice.
THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000