PR02000201008JA100 Datasheet, PDF (13/16 Pages) Vishay Siliconix – Power Metal Film Leaded Resistors

www.vishay.com
APPLICATION INFORMATION
10 ²
Z
R
10
1
PR01/02/03
Vishay BCcomponents
R_n = 1.5 Ω
R_n = 18 Ω
R_n = 1.3 kΩ
10 ^-1
10 ^-2
1
Rn = 20 kΩ
R_n = 100 kΩ
10
10 ²
f (MHz)
10 ³
PR03 Impedance as a function of applied frequency
TESTS AND REQUIREMENTS
Essentially all tests are carried out in accordance with
IEC 60115-1 specification, category LCT/UCT/56 (rated
temperature range: Lower Category Temperature, Upper
Category Temperature; damp heat, long term, 56 days).
The tests are carried out in accordance with IEC 60068-2-xx
Test Method under standard atmospheric conditions
according to IEC 60068-1, 5.3.
In the Test Procedures and Requirements table, tests
and requirements are listed with reference to the relevant
clauses of IEC 60115-1 and IEC 60068-2-xx test methods.
A short description of the test procedure is also given. In
some instances deviations from the IEC recommendations
were necessary for our method of specifying.
All soldering tests are performed with mildly activated flux.
TEST PROCEDURES AND REQUIREMENTS
IEC
60115-1
CLAUSE
IEC
60068-2-
TEST
METHOD
TEST
4.4.1
Visual examination
PROCEDURE
4.4.2
Dimensions (outline)
Gauge (mm)
Applied voltage (+ 0 %/- 10 %):
R< 10 : 0.1 V
Resistance
10   R < 100 : 0.3 V
4.5
(refer note on first
page for measuring
100   R < 1 k: 1 V
1 k  R < 10 k: 3 V
distance)
10 k  R < 100 k: 10 V
100 k  R < 1 M: 25 V
R = 1 M: 50 V
4.18
20 (Tb)
Resistance to
soldering heat
Thermal shock: 10 s; 260 °C; 3 mm from body
4.29
45 (Xa)
Component solvent
resistance
Isopropyl alcohol or H₂O
followed by brushing
4.17
20 (Ta)
Solderability
2 s; 235 °C; Solder bath method; SnPb40
3 s; 245 °C; Solder bath method; SnAg3Cu0.5
Solderability
(after ageing)
8 h steam or 16 h 155 °C;
leads immersed 6 mm:
for 2 s at 235 °C; solder bath (SnPb40)
for 3 s at 245 °C; solder bath (SnAg3Cu0.5)
REQUIREMENTS
No holes; clean surface; no damage
See Straight and Kinked Dimensions
tables
R - R_nom: max. ± 5 %
R_max.: ± (1 % R + 0.05 )
No visual damage
Good tinning ( 95 % covered);
no damage
Good tinning ( 95 % covered);
no damage
Revision: 24-Jun-13
13
Document Number: 28729
For technical questions, contact: [e-mail]
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000