MMU0102 Datasheet, PDF (12/13 Pages) Vishay Siliconix – Professional MELF Resistors

MMU 0102, MMA 0204, MMB 0207 - Professional
Professional MELF Resistors
Vishay Beyschlag
TEST PROCEDURES AND REQUIREMENTS
EN
60115-1
CLAUSE
IEC
60068-2*
TEST
METHOD
TEST
PROCEDURE
STABILITY CLASS
0.25
OR BETTER
REQUIREMENTS
PERMISSIBLE CHANGE (ΔR)
STABILITY
CLASS 0.5
OR BETTER
STABILITY CLASS
1
OR BETTER
STABILITY
CLASS 2
OR BETTER
stability for product
types:
4.32
21 (Ue₃) shear
MMU 0102 10 Ω to 221kΩ
MMA 0204 10 Ω to 332 kΩ
MMB 0207 10 Ω to 1 MΩ
45 N
1Ω to < 10 Ω
<1Ω
1Ω to < 10 Ω
<1Ω
1Ω to < 10 Ω
<1Ω
no visible damage
> 221 kΩ
> 332 kΩ
> 1 MΩ
4.33
21 (Ue₁) substrate
bending
depth 2mm,
3 times
no visible damage, no open circuit in bent position
± (0.05 % R + 5 mΩ)¹⁾
4.7
-
voltage proof U_rms = U_ins; 60 s
no flashover or breakdown
4.35
-
flammability IEC 60 695-11-5*,
needle flame test;
10 s
no burning after 30 s
Note
1. Special requirements apply to MICRO-MELF, MMU 0102:
- R < 100 Ω: ± (0.25 % R + 10 mΩ)
- 100 Ω ≤ R ≥ 221 kΩ: ± 0.1 % R
- 221 kΩ < R: ± 0.25 % R
* The quoted IEC standards are also released as EN standards with the same number and identical contents.
REVISION HISTORY
Compared to the prior revision of this datasheet, 23-Feb-04, the following changes have been applied:
• Introduction of a standardized part numbering system
• Additional emphasis on the clean balance of materials and on the compliance with various EU directives
• Revision of the current noise diagram based on new test results
• Introduction of a test and requirements for electrostatic discharge (ESD)
• No other change of technical contents
• No product change
Document Number: 28713
Revision: 18-Jul-06
For technical questions contact: [e-mail]
www.vishay.com
23