BCM48BH120120B00 Datasheet, PDF (9/16 Pages) Vicor Corporation – Fixed Ratio DC-DC Converter

2.1 MECHANICAL DRAWING
TOP VIEW ( COMPONENT SIDE )
BCM48BH120T120B00
BOTTOM VIEW
mm
(inch)
NOTES:
mm
2. DIMENSIONS ARE inch .
UNLESS OTHERWISE SPECIFIED, TOLERANCES ARE:
3. .X / [.XX] = +/-0.25 / [.01]; .XX / [.XXX] = +/-0.13 / [.005]
4. PRODUCT MARKING ON TOP SURFACE
DXF and PDF files are available on vicorpower.com
2.2 RECOMMENDED LAND PATTERN
RECOMMENDED LAND PATTERN
( COMPONENT SIDE SHOWN )
NOTES:
mm
2. DIMENSIONS ARE inch .
UNLESS OTHERWISE SPECIFIED, TOLERANCES ARE:
3. .X / [.XX] = +/-0.25 / [.01]; .XX / [.XXX] = +/-0.13 / [.005]
4. PRODUCT MARKING ON TOP SURFACE
DXF and PDF files are available on vicorpower.com
2.3 RECOMMENDED LAND PATTERN FOR PUSH PIN HEAT SINK
Notes:
1. Maintain 3.50 (0.138) Dia. keep-out zone
free of copper, all PCB layers.
2. (A) minimum recommended pitch is 24.00 (0.945)
this provides 7.50 (0.295) component
edge–to–edge spacing, and 0.50 (0.020)
clearance between Vicor heat sinks.
(B) Minimum recommended pitch is 25.50 (1.004).
This provides 9.00 (0.354) component
edge–to–edge spacing, and 2.00 (0.079)
clearance between Vicor heat sinks.
3. V•I Chip™ module land pattern shown
for reference only, actual land pattern may differ.
Dimensions from edges of land pattern
to push–pin holes will be the same for
all half size V•I Chip products.
4. RoHS compliant per CST–0001 latest revision.
5. Unless otherwise specified:
Dimensions are mm (inches)
tolerances are:
x.x (x.xx) = ±0.3 (0.01)
x.xx (x.xxx) = ±0.13 (0.005)
6. Plated through holes for grounding clips (33855)
shown for reference. Heat sink orientation and
device pitch will dictate final grounding solution.
(NO GROUNDING CLIPS)
+Out
-Out
43
A
B
C
D
J
K
L
M
21
+In
NC
E
F
TM
G
H
NC
PC
-In
Bottom View
Signal
Name
+In
–In
NC
TM
NC
PC
+Out
–Out
Designation
A1-B1, A2-B2
L1-M1, L2-M2
E1
F2
G1
H2
A3-D3, A4-D4
J3-M3, J4-M4
(WITH GROUNDING CLIPS)
BCM^® Bus Converter
Page 9 of 16
Rev 1.2
07/2015
vicorpower.com
800 927.9474