LCAS6-10-L Datasheet, PDF (2/4 Pages) Vicor Corporation – VI CHIP Evaluation Board

Specifications
6. TEMPERATURE MONITOR (TM)
A DVM can be connected between TM (positive) and
SG (negative) to monitor the internal temperature of
the V•I Chip.
Ø 0.20 Typ
7. PRIMARY CONTROL (PC)
The PC can be used to disable the V•I Chip, monitor status,
or provide a primary referenced bias supply.
a.) Connecting PC to SG or to the –IN will disable
the V•I Chip.
b.) Connecting a DVM or oscilloscope between PC
(positive) and SG or –IN (negative) will indicate the
status of the V•I Chip. Please note that the V•I Chip
does not have active current sinking capability.
+IN
TM
1.66
SG
PC
–IN
+OUT
CL
J1
– OUT
2.67
c.) Connecting a load between PC (positive) and SG
Figure 1— V•I Chip demo board layout and dimensional drawing,
or –IN (negative) will provide a primary referenced
Component side. (Dimensions are in inches)
P ^{R E L I M I NA RY biassupply.}
8. EFFICIENCY MEASUREMENT
As the V•I Chip can deliver and consume large currents, the
effect of the PCB must be considered when making an
efficiency measurement. Be certain to accurately measure
the voltage directly at the V•I Chip using the appropriate
pair of contact points located at the corners of the V•I Chip.
RECOMMENDED HARDWARE:
QTY Description
Manufacturer
Vicor
P/N
P/N
4 Ring Lug
4 #10-32 Screw
4 #10 Flat Washer
4 #10 Lock Washer
4 #10 Hex Nut
PANDUIT LCAS6-10-L
}
Kit # 26647
All hardware is Stainless Steel except Ring Lug.
Kit # 26647 included with evaluation board.
ORDERING INFORMATION:
The evaluation board is specified by suffixing “–EB” to the
appropriate V•I Chip model number that includes in-board
mounting and integral pin fin heatsink. See vicorpower.com for
model number listings.
45
Vicor Corporation Tel: [phone] vicorpower.com V•I Chip Evaluation Board
Rev. 1.2
Page 2 - 4