BCM48BX120Y120B00 Datasheet, PDF (19/20 Pages) Vicor Corporation – Isolated Fixed Ratio DC-DC Converter

Recommended Heat Sink Push Pin Location
Notes:
1. Maintain 3.50 (0.138) Dia. keep-out zone
free of copper, all PCB layers.
2. (A) minimum recommended pitch is 24.00 (0.945)
this provides 7.50 (0.295) component
edge–to–edge spacing, and 0.50 (0.020)
clearance between Vicor heat sinks.
(B) Minimum recommended pitch is 25.50 (1.004).
This provides 9.00 (0.354) component
edge–to–edge spacing, and 2.00 (0.079)
clearance between Vicor heat sinks.
3. V•I Chip™ module land pattern shown
for reference only, actual land pattern may differ.
Dimensions from edges of land pattern
to push–pin holes will be the same for
all half size V•I Chip products.
4. RoHS compliant per CST–0001 latest revision.
5. Unless otherwise specified:
Dimensions are mm (inches)
tolerances are:
x.x (x.xx) = ±0.3 (0.01)
x.xx (x.xxx) = ±0.13 (0.005)
6. Plated through holes for grounding clips (33855)
shown for reference. Heat sink orientation and
device pitch will dictate final grounding solution.
(NO GROUNDING CLIPS)
BCM48Bx120y120B00
(WITH GROUNDING CLIPS)
BCM^® Bus Converter
Page 19 of 20
Rev 1.3
08/2016
vicorpower.com
800 927.9474