CS300 Datasheet, PDF (7/8 Pages) Vectron International, Inc – Clock Smoother

Evaluation Board
Turret Terminal 4 Places
Input
Frequency
Edge
Mount
SMA
3 Places
Output
Frequency
Evaluation
boards are
available
upon
request.
LED
Lights
Up
When
Locked
Jumper Sockets 3 Places
Enable / Disable
Frequency Select A & B
FAQ’s
Q1: What are the different input frequencies available?
A: The CS-300 is able to handle any input frequency between 10 MHz and 700 MHz.
(A list of standard frequencies is available on page 8.)
Q2: How many different input frequencies can a specific CS-300 accept?
A: Each CS-300 can be programmed to accept up to 2 different input frequencies.
Q3: If there is only one set of input pins, how can your unit accept 2 different frequencies?
A: The customer is required to supply a multiplexer which would switch between the
different input frequencies. The multiplexers’select pin would need to be sync’d to
the select pin of the CS-300.
Q4: What is the lock time for the CS-300?
A: The exact lock time will depend on the specific input frequency. It should be noted that
in all cases the lock time will be significantly less than 1 second.
Q5: What type of noise on the supply line can the CS-300 suppress?
A: The CS-300 is designed to clean up noise on the Input Clock Signal, it is not designed
to clean up noisy power supplies. If excessive noise is present on the supply line it
may degrade the output jitter performance. Additional external filtering may be
required. Please consult with your power supply vendor on the best way to filter noise
of your supply line.