VCC4_10 Datasheet, PDF (6/9 Pages) Vectron International, Inc – 1.8, 2.5, 3.3, 5.0 volt CMOS Oscillator

VCC4 Data sheet
Enable/Disable Functional Description
Under normal operation the Enable/Disable is left open, or set to a logic high state, and the VCC4 is
oscillating. When the E/D is set to a logic low, the oscillator stops and the output is in a high impedance
state. This helps reduce power consumption as well as facilitating board testing and troubleshooting.
TriState Functional Description
Under normal operation the Tristate is left open or set to a logic high state. When the Tri-State is set to a
logic low, the oscillator remains active but the output buffer is in a high impedance state. This helps
facilitate board testing and troubleshooting.
Outline Diagrams, Pad Layout and Pin Out
Table 5. Pinout
Pin #
1
2
3
4
Symbol
E/D or NC
GND
f_O
V_DD
Function
Tristate, Enable/Disable or NC
Electrical and Case Ground
Output Frequency
Supply Voltage
1.30 max
Contact Pads are gold over nickel
Figure 9, Package drawing
Vectron International 267 Lowell Rd, Hudson NH 03051 Tel: 1-88-VECTRON-1 e-mail: [e-mail]