VCC4_10 Datasheet, PDF (2/9 Pages) Vectron International, Inc – 1.8, 2.5, 3.3, 5.0 volt CMOS Oscillator

VCC4 Data sheet
Performance Characteristics
Table 1. Electrical Performance, 5V option
Parameter
Symbol
Min
Typical Maximum Units
Frequency
Operating Supply Voltage ¹
Absolute Maximum Supply Voltage
f_O
1.544
V_DD
4.5
-0.7
75.000
5.5
7.0
MHz
V
V
Supply Current, Output Enabled
I_DD
< 1.50 MHz
mA
7
1.500 to 20 MHz
10
20.01 to 50 MHz
30
50.01 to 75 MHz
40
Supply Current, Out disabled
Output Logic Levels
Output Logic High²
Output Logic Low²
Output Logic High Drive
Output Logic Low Drive
Output Rise/Fall Time²
< 20.00 MHz
I_DD
V_OH
V_OL
I_OH
I_OL
t_R/t_F
0.9*V_DD
16
16
30
uA
V
0.1*V_DD
V
mA
mA
ns
8
20.01 to 50.00 MHz
5
50.01 to 75.00 MHz
Duty Cycle³ (ordering option)
SYM
2
45/55
%
Operating temperature (ordering option)
Stability⁴ (ordering option)
-10/70 or -40/85
°C
±25, ±50, ±100
ppm
RMS Jitter, 12kHz to 20 MHz
0.5
1
ps
Period Jitter
ps
RMS
3.0
Peak to Peak
Output Enable/Disable⁵
21
V
Output Enabled
4.0
Output Disabled
Internal Enable Pull-Up resistor⁵
0.8
100
Kohm
Start-up time
8
ms
1. A 0.01uF and a 0.1uF capacitor should be located as close to the supply as possible (to ground) is recommended.
2. Figure 1 defines these parameters. Figure 2 illustrates the operating conditions under which these parameters are tested and
specified.
3. Symmetry is measured defined as On Time/Period.
4. Includes calibration tolerance, operating temperature, supply voltage variations, and shock and vibration (not under operation). 50
and 100ppm options include aging.
5. Output will be enabled if enable/disable is left open.
V_OH
50%
V_OL
t_R
t_F
On Time
Period
IDD
+
VDD -
.1μF
.01μF
4
1
IC
VC ⁺
-
2³
15pF
Figure 1. Output Waveform
Figure 2. Typical Output Test Conditions (25±5°C)
Vectron International 267 Lowell Rd, Hudson NH 03051 Tel: 1-88-VECTRON-1 e-mail: [e-mail]