CCFCCA-25M125 Datasheet, PDF (3/7 Pages) Vectron International, Inc – 3.3, 5.0 volt CMOS Oscillator

C-TYPE Data Sheet
Table 2. Electrical Performance, 3.3V option
Parameter
Symbol
Frequency
f_O
Operating Supply Voltage ¹
V_DD
Absolute Maximum Operating Voltage
Supply Current, Output Enabled
I_DD
< 1.500 MHz
1.5 to 20 MHz
20.01 to 50 MHz
50.01 to 85 MHz
85.01 to 190 MHz
Supply Current, Output disabled
I_DD
Output Logic Levels
Output Logic High²
V_OH
Output Logic Low²
V_OL
Output Logic High Drive
I_OH
Output Logic Low Drive
I_OL
Output Rise/Fall Time²
t_R/t_F
< 1.00 MHz
1.00 to 20.00 MHz
20.01 to 50.00 MHz
50.01 to 90.00 MHz
90.01 to 190.00 MHz
Duty Cycle³ (ordering option)
SYM
Operating Temperature (ordering option)
Storage Temperature
Stability⁴ (ordering option)
RMS Jitter, 12kHz to 20 MHz
RMS Jitter
Output Enable/Disable⁵
Output Enabled
Output Disabled
Internal Enable Pull-Up resistor⁵
Start-up time
Min
0.012
2.97
-0.5
Typical
3.3
Maximum
190.000
3.63
5.0
5
7
20
30
50
30
0.9*V_DD
8
8
0.1*V_DD
200
6
4
3
2
45/55
-10/70 or –40/85
-55
125
±20, ±25, ±32, ±50, ±100
0.5
1
2.5
2.0
0.5
100
10
Units
MHz
V
V
mA
uA
V
V
mA
mA
ns
%
°C
°C
ppm
ps
ps
V
Kohm
ms
1. A 0.01uF and a 0.1uF capacitor should be located as close to the supply as possible (to ground) is recommended.
2. Figure 3 defines these parameters. Figure 4 illustrates the operating conditions under which these parameters are tested and
specified. For Fo>90MHz, rise and fall time is measured 20 to 80%.
3. Symmetry is measured defined as On Time/Period.
4. Includes calibration tolerance, operating temperature, supply voltage variations, aging and shock and vibration (not under
operation).
5. Output will be enabled if enable/disable is left open.
VOH
50%
V OL
tR
tF
On Time
Period
Figure 3. Output Waveform
I DD
+ _{.1µF .01µF}
VDD -
4
1
IC
VC ⁺
-
3
2
15pF
Figure 4. Typical Output Test Conditions (25±5°C)
Vectron International 267 Lowell Rd, Hudson NH 03051 Tel: 1-88-VECTRON-1 e-mail [e-mail]