CCFCCA-25M125 Datasheet, PDF (2/7 Pages) Vectron International, Inc – 3.3, 5.0 volt CMOS Oscillator

C-TYPE Data Sheet
Performance Characteristics
Table 1. Electrical Performance, 5V option
Parameter
Symbol Min
Typical Maximum Units
Frequency
Operating Supply Voltage ¹
f_O
0.012
125.000 MHz
V_DD
4.5
5.0
5.5
V
Absolute Maximum Supply Voltage
-0.7
7.0
V
Supply Current, Output Enabled
I_DD
<1.5 MHz
mA
7
1.5 to 20 MHz
10
20.01 to 50 MHz
30
50.01 to 85 MHz
50
85.01 to 125 MHz
60
Supply Current, Out disabled
Output Logic Levels
Output Logic High²
Output Logic Low²
Output Logic High Drive
Output Logic Low Drive
Output Rise/Fall Time²
< 1.00 MHz
I_DD
V_OH
V_OL
I_OH
I_OL
t_R/t_F
0.9*V_DD
16
16
30
uA
V
0.1*V_DD
V
mA
mA
ns
200
1.0 to 20.00 MHz
8
20.01 to 50.00 MHz
5
50.01 to 125.00 MHz
2
Duty Cycle³ (ordering option)
SYM
45/55
%
Operating Temperature (ordering option)
-10/70 or -40/85
°C
Storage Temperature
Stability⁴ (ordering option)
-55
125
°C
±20, ±25, ±32, ±50, ±100
ppm
RMS Jitter, 12kHz to 20 MHz
0.5
1
ps
Period Jitter, RMS
2.5
ps
Output Enable/Disable⁵
V
Output Enabled
4.0
Output Disabled
0.8
Internal Enable Pull-Up resistor⁵
100
Kohm
Start-up time
10
ms
1. A 0.01uF and a 0.1uF capacitor should be located as close to the supply as possible (to ground) is recommended.
2. Figure 1 defines these parameters. Figure 2 illustrates the operating conditions under which these parameters are tested and
specified.
3. Symmetry is measured defined as On Time/Period.
4. Includes calibration tolerance, operating temperature, supply voltage variations, aging and shock and vibration (not under
operation).
5. Output will be enabled if enable/disable is left open.
VOH
50%
V OL
tR
tF
On Time
Period
Figure 1. Output Waveform
I DD
+ _{.1µF .01µF}
VDD -
4
1
IC
VC ⁺
-
3
2
15pF
Figure 2. Typical Output Test Conditions (25±5°C)
Vectron International 267 Lowell Rd, Hudson NH 03051 Tel: 1-88-VECTRON-1 e-mail: [e-mail]