English
Language : 

BCN Datasheet, PDF (8/9 Pages) Bi technologies – Thick Film Chip Resistor Arrays
Thick Film Chip Arrays
BCN Series
Ordering Information
Model Series
BCN 4
D
B
No. of Resistors:
BCN 4D = 4 Resistors
Circuit Configuration:
D = Isolated
Edge Option (B = Square Edge):
BCN 4D: Scalloped Edge Only - No Code Used
I
102
J
7
S
Construction Option:
No code = Standard product
S = Sulphur resistant - only
on BCN4DxxxJ7
Packaging Option:
7” or 13”
(See Table A)
Tolerance: ±5%
Resistance Code
Termination Code:
I = Interior (Concave) Termination
(Only available in BCN 4 DBI)
Model Series
Width:
10 = 1.0mm
16 = 1.6mm
21 = 2.1mm
31 = 3.1mm
BCN 16 4
A
B
I 102 J
7
S
Construction Option:
No code = Standard product
S = Sulphur resistant - only
on BCN 104/164/168RB
Packaging Option:
7” or 13”
(See Table A)
No. of Resistors:
BCN 10 / 06 4 / 16 4 = 4 Resistors
BCN 16 8R / 16 8S = 8 Resistors
BCN 21 / 31 8R / 31 8S = 8 Resistors
Tolerance:
F = ±1% (BCN 4D / 16 4 / 31 8RB / 31 8SB)
G = ±2% (BCN 16 4, 31 8RB / 8SB Only)
J = ±5% (Standard)
(Use JP for Jumper Chip Array - BCN 16 4 / 31)
Circuit Configuration:
A = Isolated (BCN 10 / 16 4A)
R = Bussed (Reversed) (BCN 16 8R / 31 8R)
S = Bussed (Standard) (BCN 21 / 16 8S / 31 8S)
Edge Option (B = Square Edge):
Scalloped Edge - No Code Used (Standard)
Square Edge Only - Use Code ‘B’
Resistance Code:
3 digits for all E24 values in 2% or 5% tolerance
4 digits for uniquely E96 values in any tolerance and
for any value in 1% tolerance
Termination Code:
I = Interior (Concave) Termination
No code used for exterior termination ( Standard)
All interior termination requires ‘B’ for square edge
(BCN 16 4ABI / 31 8RBI / 31 8SBI)
See ‘Model Styles’ for Available Options
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
© TT Electronics plc
BI Technologies IRC Welwyn
www.ttelectronicsresistors.com
04.16