TLP250H Datasheet, PDF (5/16 Pages) Toshiba Semiconductor – Buffer logic type (totem pole output)

9. Recommended Operating Conditions (Note)
TLP250H,TLP250HF
Characteristics
Symbol
Note
Min Typ. Max Unit
Input on-state current
Input off-state voltage
Supply voltage
Peak high-level output current
Peak low-level output current
Operating frequency
I_F(ON)
V_F(OFF)
V_CC
I_OPH
I_OPL
f
(Note 1)
(Note 2)
(Note 3)
6.5

10
mA
0

0.8
V
10

30


-2.0
A

 +2.0


250 kHz
Note: The recommended operating conditions are given as a design guide necessary to obtain the intended
performance of the device. Each parameter is an independent value. When creating a system design using
this device, the electrical characteristics specified in this datasheet should also be considered.
Note: A ceramic capacitor (0.1 µF) should be connected between pin 8 and pin 5 to stabilize the operation of a high-
gain linear amplifier. Otherwise, this photocoupler may not switch properly. The bypass capacitor should be
placed within 1 cm of each pin.
Note : If the rising slope of the supply voltage (V_CC) for the detector is steep, stable operation of the internal circuits
cannot be guaranteed.
Be sure to set 3.0 V/µs or less for a rising slope of the V_CC.
Note 1: The rise and fall times of the input on-current should be less than 0.5 µs.
Note 2: Denotes the operating range, not the recommended operating condition.
Note 3: Exponential waveform. I_OPH ≥ -0.65 A (≤ 80 ns), I_OPL ≤ 0.65 A (≤ 80 ns), T_a = 125 , V_CC = 20 V
©2015 Toshiba Corporation
5
2015-12-24
Rev.4.0