TLP2166A Datasheet, PDF (2/11 Pages) Toshiba Semiconductor – PHOTOCOUPLER GaAℓAs Ired & PHOTO-IC

TLP2166A
Absolute Maximum Ratings (Ta=25°C)
CHARACTERISTIC
SYMBOL RATING UNIT
Forward Current
(Note 1)
IF
15
mA
Forward current derating (Ta ≥ 95℃)
(Note 1) ⊿IF/⊿Ta -0.5
mA/℃
Peak Transient Forward Current
(Note 1,2)
IFP
1
A
Reverse Voltage
(Note 1)
VR
5
V
Output Current
(Note 1)
IO
10
mA
Output Voltage
(Note 1)
VO
6
V
Supply Voltage
VCC
6
V
Output Power Dissipation
PO
40
mW
Operating Temperature Range
Topr -40 to 100
°C
Storage Temperature Range
Tstg -55 to 125
°C
Lead Soldering Temperature
(10 s)
Tsol
260
°C
Isolation Voltage (AC,1 min, R.H.≤ 60%,Ta=25°C) (Note 3)
BVs
2500
Vrms
Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the
significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even
if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum
ratings.
Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook
(“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test
report and estimated failure rate, etc).
Note 1: Each Channel.
Note 2: Pulse width ≤ 1 μs, 300 pps.
Note 3: This device is regarded as a two terminal device : pins 1, 2, 3 and 4 are shorted together,
as are pins 5, 6, 7 and 8.
Recommended Operating Conditions
CHARACTERISTIC
SYMBOL MIN TYP. MAX UNIT
Input Current , ON
Input Voltage , OFF
Supply Voltage*
Operating Temperature
(Note 1) IF(ON)
5
―
10
mA
(Note 1) VF(OFF)
0
―
0.8
V
(Note 4)
VCC
3.0
3.3
3.6
V
Topr
-40
―
100
°C
* This item denotes operating range, not meaning of recommended operating conditions.
Note 4: The detector of this product requires a power supply voltage (VCC) of 3.0 V or higher for
stable operation.
If the VCC is lower than this value, an ICCH may increase, or an output may be unstable.
Be sure to use the product after checking the supply current, and the operation of a power-on/-off
Note 5: A ceramic capacitor (0.1 μF) should be connected from pin 8 (VCC) to pin 5 (GND) to stabilize the operation
of the high gain linear amplifier. Failure to provide the bypass may impair the switching property.
The total lead length between capacitor and coupler should not exceed 1 cm.
2
2008-11-27