TLP117_14 Datasheet, PDF (2/7 Pages) Toshiba Semiconductor – PDP (Plasma Display Panel),FA (Factory Automation),High-Speed Interface

TLP117
Absolute Maximum Ratings (Ta=25°C)
Characteristic
Symbol Rating
Unit
Forward current
Forward current derating (Ta≥85°C)
IF
25
∆IF/∆Ta
-0.7
mA
mA/°C
Peak transient forward current (Note 1)
IFPT
1
A
Reverse voltage
VR
6
V
Output current
IO
10
mA
Output voltage
Supply voltage
Output power dissipation
Operating temperature range
Storage temperature range
VO
6
V
VCC
6
V
PO
40
mW
Topr -40 to 105
°C
Tstg -55 to 125
°C
Lead solder temperature(10s)
Isolation voltage (AC,1 minute, R.H. ≤ 60%, Ta=25°C)
Tsol
(Note 2) BVs
260
3750
°C
Vrms
Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the
significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if
the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum
ratings.
Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook
(“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test
report and estimated failure rate, etc).
Note 1: Pulse width PW≤1μs, 300 pps.
Note 2: This device is regarded as a two-terminal device: pins 1 and 3 are shorted together, and pins 4,5 and 6 are
shorted together.
Recommended Operating Conditions
Characteristic
Symbol
Min
Typ.
Max
Unit
Input current , ON
Input voltage , OFF
IF(ON)
10
—
16
mA
VF(OFF)
0
—
1.0
V
Supply voltage(*)
(Note 3)
VCC
4.5
5.0
5.5
V
* This item denotes operating ranges, not meaning of recommended operating conditions.
Note: Recommended operating conditions are given as a design guideline to obtain expected performance of the
device. Additionally, each item is an independent guideline respectively. In developing designs using this
product, please confirm specified characteristics shown in this document.
Note 3: The detector of this product requires a power supply voltage (VCC) of 4.5 V or higher for stable operation. If
VCC is lower than this value, I_CC may increase or the output may be unstable.
Be sure to use the product after checking the supply current, and the operation of a power-on/-off.
2
2014-09-01