TLP116_07 Datasheet, PDF (2/8 Pages) Toshiba Semiconductor – PHOTO-IC PDP(Plasma Display Panel)

TLP116
Absolute Maximum Ratings (Ta=25°C)
Characteristic
Forward current
Forward current derating (Ta≥85°C)
Peak transient forward current (Note1)
Reverse voltage
Output current
Output voltage
Supply voltage
Output power dissipation
Operating temperature range
Storage temperature range
Lead solder temperature(10s)
Isolation voltage
(AC,1min.,R.H.≤60%,Ta=25°C)
(Note2)
Symbol
IF
ΔIF/ΔTa
IFPT
VR
IO
VO
VCC
PO
Topr
Tstg
Tsol
Rating
20
-0.5
1
5
10
6
6
40
-40~100
-55~125
260
BVs
3750
Unit
mA
mA/°C
A
V
mA
V
V
mW
°C
°C
°C
Vrms
Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the
significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even
if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum
ratings and the operating ranges.
Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook
(“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test
report and estimated failure rate, etc).
Recommended Operating Conditions
Characteristic
Symbol
Min
Typ.
Max
Unit
Input current , ON
Input voltage , OFF
IF(ON)
8
VF(OFF)
0
—
18
mA
—
0.8
V
Supply voltage
Operating temperature
(Note3)
VCC
Topr
4.5
5.0
5.5
V
-40
—
100
°C
Note: Recommended operating conditions are given as a design guideline to obtain expected performance of the
device. Additionally, each item is an independent guideline respectively. In developing designs using this
product, please confirm specified characteristics shown in this document.
Correlation between Input current , switching speed and drive circuit
(reference information).
Input current
(IF)
test Circuit
Typical switching speed
12mA
1
(Page 4)
21 – 23 MBd
8mA
1
(Page 4)
18 – 20 MBd
8mA
2
(Page 4,With Speed up capacitor)
23 – 27 MBd
Note1 : Pulse width PW≤1us,300pps.
Note2 : This device is regarded as a two terminal device : pins 1 and 3 are shorted together, as are pins 4,5 and 6.
Note3 : The detector of this product requires a power supply voltage (VCC) of 4.5 V or higher for stable operation.
If the VCC is lower than this value, an ICC may increase, or an output may be unstable.
Be sure to use the product after checking the supply current, and the operation of a power-on/-off.
2
2007-10-01