TIBPAL22VP10-20C_15 Datasheet, PDF (9/24 Pages) Texas Instruments – HIGH-PERFORMANCE IMPACT-X

Obsolete Device
TIBPAL22VP10-20C
HIGH-PERFORMANCE IMPACT-X ™ PROGRAMMABLE ARRAY LOGIC CIRCUITS
SRPS013 − D2943, FEBRUARY 1987 − REVISED JUNE 1991
electrical characteristics over recommended operating free-air temperature range
PARAMETER
V_IK
V_OH
V_OL
I_OZH
I_OZL
Any output
Any I/O
I_I
I_IH
I_IL
I_OS‡
I_CC
V_CC = 4.75 V,
V_CC = 4.75 V,
V_CC = 4.75 V,
V_CC = 5.25 V,
V_CC = 5.25 V,
V_CC = 5.25 V,
V_CC = 5.25 V,
V_CC = 5.25 V,
V_CC = 5.25 V,
V_CC = 5.25 V,
TEST CONDITIONS
I_I = − 18 mA
I_OH = − 3.2 mA
I_OL = 16 mA
V_O = 2.7 V
V_O = 0.4 V
V_I = 5.5 V
V_I = 2.7 V
V_I = 0.4 V
V_O = 0.5 V
V_I = GND,
Outputs open
MIN TYP^†
2.4 3.5
0.35
− 30
140
MAX
− 1.2
0.5
0.1
− 100
− 250
1
25
− 0.25
− 90
180
UNIT
V
V
V
mA
μA
mA
μA
mA
mA
mA
switching characteristics over recommended ranges of supply voltage and operating free-air
temperature (unless otherwise noted)
PARAMETER
FROM
(INPUT)
TO
(OUTPUT)
TEST CONDITION
MIN TYP^† MAX UNIT
f_max§
t_pd
t_pd
t_pd
t_en
t_dis
I, I/O
I, I/O (reset)
CLK
I, I/O
I, I/O
I/O
Q
Q
I/O, Q
I/O, Q
C_L = 50 pF,
R1 = 300 Ω,
R2 = 390 Ω,
See Figure 4
37
50
MHz
12
20 ns
12
20 ns
8
12 ns
12
20 ns
12
20 ns
† _{All typical values are at VCC = 5 V, TA = 25°C.}
‡ _{Not more than one output should be shorted at a time, and the duration of the short circuit should not exceed one second. VO is set at 0.5 V to}
avoid test problems caused by test equipment ground degradation.
§ _{fmax (with feedback)}
+
tsu
)
1
tpd (CLK
to
Q), ^{fmax without feedback can be calculated as}
fmax (without feedback)
+
tw high
1
)
.
tw low
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
9