SBOU087A Datasheet, PDF (9/35 Pages) Texas Instruments – Multi-Cal-System Evaluation Module

www.ti.com
Starter System Setup
2 Starter System Setup
Figure 7 shows the system setup for the Multi-Cal-System EVM. The PC runs software that communicates
with the USB-DAQ-Platform. The USB-DAQ-Platform generates the digital signals used to communicate
with the Multi-Cal-System EVM.
RS-232 or
IEEE488
DMM
±15V
Loop or
DUT
Power
USB DAQ
Platform
Multi-Cal-Master
EVM
Power
Pressure
Source
Multi-Cal-Interface Board
Pressure Sensors in Pressure Manifold
Figure 7. Multi-Cal-System EVM Hardware Setup
2.1 Electrostatic Discharge Warning
Many of the components on the Multi-Cal-System EVM are susceptible to damage by electrostatic
discharge (ESD). Customers are advised to observe proper ESD handling precautions when unpacking
and handling the EVM, including the use of a grounded wrist strap at an approved ESD workstation.
CAUTION
Failure to observe ESD handling procedures may result in damage to EVM
components.
SBOU087A – August 2010 – Revised April 2011
Multi-Cal-System Evaluation Module
9
Submit Documentation Feedback
Copyright © 2010–2011, Texas Instruments Incorporated