|
SBOU087A Datasheet, PDF (17/35 Pages) Texas Instruments – Multi-Cal-System Evaluation Module | |||
|
◁ |
www.ti.com
Starter System Setup
Figure 16 shows how to connect the Multi-Cal-Power cable to power supplies and to the DMM. This
connection is for voltage output modules (that is. three-wire and four-wire connections). See Table 3 for
information on how to set the jumpers on the Multi-Cal-Test PCA for current loop configuration.
HP34401
DMM
Sense Input
HI
HI
LO
LO
I
Common ground between 15V and 5V supply
Linear
Power Supply
Linear
Power Supply
VmP
VmN
+15V
GND -15V
POS
NEG
5V
ImP
ImN
Ammeter
plugs are
not connected
15vP
GND
15vN
SupP
SupN
J9
Multi-Cal-Master-PCA
Figure 16. Connect Multi-Cal-Power-Cable to Power Supplies (Voltage Output)
SBOU087A â August 2010 â Revised April 2011
Multi-Cal-System Evaluation Module
17
Submit Documentation Feedback
Copyright © 2010â2011, Texas Instruments Incorporated
|
▷ |