THS4520_14 Datasheet, PDF (8/37 Pages) Texas Instruments – WIDEBAND, LOW NOISE, LOW DISTORTION FULLY DIFFERENTIAL AMPLIFIER

THS4520
SLOS503B – SEPTEMBER 2006 – REVISED JULY 2007
TYPICAL CHARACTERISTICS
www.ti.com
TYPICAL AC PERFORMANCE: V_S+ – V_S– = 5 V
Test conditions unless otherwise noted: V_S+ = +2.5 V, V_S– = –2.5 V, CM = open, V_O = 2 V_PP, R_F = 499 Ω, R_L = 200 Ω
Differential, G = 0 dB, Single-Ended Input, Input and Output Referenced to Midrail
Small-Signal Frequency Response
Large Signal Frequency Response
HD2
HD3
HD2
HD3
HD2
HD3
Harmonic Distortion⁽¹⁾
HD2
HD3
HD2
HD3
HD2
HD3
HD2
HD3
0.1 dB Flatness
S-Parameters
Slew Rate
Transient Response
Output Voltage Swing
Input Offset Voltage
Input Bias Current
Open Loop Gain and Phase
Input Referred Noise
Quiescent Current
Power Supply Current
Output Balance Error
CM Small-Signal Frequency Response
CM Input Bias Current
Differential Output Offset Voltage
Output Common-Mode Offset
vs Frequency, V_O = 2 V_PP
vs Frequency, V_O = 2 V_PP
vs Frequency, V_O = 4 V_PP
vs Frequency, V_O = 4 V_PP
vs Output Voltage Swing, f = 1 MHz
vs Output Voltage Swing, f = 1 MHz
vs Output Voltage Swing, f = 8 MHz
vs Output Voltage Swing, f = 8 MHz
vs Load Resistance, f = 1 MHz
vs Load Resistance, f = 1 MHz
vs Load Resistance, f = 8 MHz
vs Load Resistance, f = 8 MHz
vs Output common-mode voltage
vs Output common-mode voltage
vs Frequency
vs Output Voltage
Gain = 6 dB, V_O = 4 V_PP
Gain = 6 dB, V_O = 2 V_PP
vs Load Resistance
vs Input Common-Mode Voltage
vs Supply Voltage
vs Frequency
vs Frequency
vs Supply Voltage
vs Supply Voltage in Powerdown Mode
vs Frequency
vs CM Input Voltage
vs CM Input Voltage
vs CM Input Voltage
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Figure 12
Figure 13
Figure 14
Figure 15
Figure 16
Figure 17
Figure 18
Figure 19
Figure 20
Figure 21
Figure 22
Figure 23
Figure 24
Figure 25
Figure 26
Figure 27
Figure 28
Figure 29
Figure 30
Figure 31
Figure 32
Figure 33
(1) For additional plots, see the Applications section.
8
Submit Documentation Feedback