SLOU330 Datasheet, PDF (6/18 Pages) Texas Instruments – EVM Description

Initial EVM Setup and Basic Test Procedure
Select AFE722x
for ADC
Perform FFT
capture
Enter ADC
sampling rate
Enter desired
input frequency
www.ti.com
4.3 TX Path Using TSW3100
First the AFE722x digital interface needs to be configured to match the serial LVDS interface from the
TSW3100.
The following control registers need to be set in the ‘General Setup’ tab of the AFE722x programming
software. Also the USB communication warning sign should be monitored after the USB reset to ensure
proper communication with the AFE722x EVM.
Table 1. Control Registers
Register Bit
Interface
Master Override
Serial LVDS
Data Orientation
Format
Clock Delay
Clock Delay
Frame Clock Delay
Frame Clock Delay
Setting
Serial LVDS
Enabled
2 Wire
MSB first
2s Complement
Enabled
300ps
Disabled
0ps
The data coming from the TSW3100 is edge aligned while the AFE722x expects the serial LVDS data to
arrive edge centered. Here the programmable clock delay inside the AFE722x can be used to delay the
edge aligned clock closer towards the center of the data.
DCLK
Data
The table below shows clock delays for listed DAC sampling rates that showed proper operation.
6
EVM Description
Copyright © 2011, Texas Instruments Incorporated
SLOU330 – December 2011
Submit Documentation Feedback