TMS320F28379S_16 Datasheet, PDF (57/213 Pages) Texas Instruments – Programmable Control Law Accelerator

www.ti.com
TMS320F28379S, TMS320F28377S
TMS320F28376S, TMS320F28375S, TMS320F28374S
SPRS881C – AUGUST 2014 – REVISED MAY 2016
5.7.2.1 Reset Sources
The following reset sources exist on this device: XRS, WDRS, NMIWDRS, SYSRS, SCCRESET, and
HIBRESET. See the Reset Signals table in the System Control chapter of the TMS320F2837xS Delfino
Microcontrollers Technical Reference Manual.
The parameter t_h(boot-mode) must account for a reset initiated from any of these sources.
CAUTION
Some reset sources are internally driven by the device. Some of these sources
will drive XRS low. Use this to disable any other devices driving the boot pins.
The SCCRESET and debugger reset sources do not drive XRS; therefore, the
pins used for boot mode should not be actively driven by other devices in the
system. The boot configuration has a provision for changing the boot pins in
OTP; for more details, see the TMS320F2837xS Delfino Microcontrollers
Technical Reference Manual.
5.7.2.2 Reset Electrical Data and Timing
Table 5-4 shows the reset (XRS) timing requirements. Table 5-5 shows the reset (XRS) switching
characteristics. Figure 5-5 shows the power-on reset. Figure 5-6 shows the warm reset.
t_h(boot-mode)
t_w(RSL2)
Table 5-4. Reset (XRS) Timing Requirements
Hold time for boot-mode pins
Pulse duration, XRS low on warm reset
MIN
MAX UNIT
1.5
ms
3.2
µs
Table 5-5. Reset (XRS) Switching Characteristics
over recommended operating conditions (unless otherwise noted)
PARAMETER
MIN
TYP
t_w(RSL1)
Pulse duration, XRS driven low by device after supplies are
stable
100
t_w(WDRS)
Pulse duration, reset pulse generated by watchdog
512t_c(OSCCLK)
MAX
UNIT
µs
cycles
Copyright © 2014–2016, Texas Instruments Incorporated
Specifications
57
Submit Documentation Feedback
Product Folder Links: TMS320F28379S TMS320F28377S TMS320F28376S TMS320F28375S TMS320F28374S