 English |
|
|
|
|
|
|
|
| TS3USB30E_13 Datasheet, PDF (4/20 Pages) Texas Instruments – ESD PROTECTED, HIGH-SPEED USB 2.0 (480-Mbps) 1:2 MULTIPLEXER/DEMULTIPLEXER SWITCH WITH SINGLE ENABLE | |||
| |||
| ◁ |
TS3USB30E
SCDS255E â DECEMBER 2008 â REVISED AUGUST 2012
www.ti.com
ELECTRICAL CHARACTERISTICS(1)
over operating free-air temperature range (unless otherwise noted)
PARAMETER
TEST CONDITIONS
MIN TYP(2) MAX UNIT
VIK
IIN
IOZ (3)
Control inputs
IOFF
D+ and Dâ
ICC
ÎICC (4)
Cin
Cio(OFF)
Cio(ON)
ron (5)
Îron
ron(flat)
Control inputs
Control inputs
VCC = 3 V,
VCC = 4.3 V, 0 V,
VCC = 4.3 V,
VI = 0,
VCC = 0 V,
VI = 0,
VCC = 4.3 V,
VCC = 4.3 V,
VCC = 0 V,
VCC = 3.3 V,
VCC = 3.3 V,
VCC = 3 V,
VCC = 3 V,
VCC = 3 V,
II = â18 mA
VIN = 0 to 4.3 V
VO = 0 to 3.6 V,
Switch OFF
VO = 0 to 4.3 V,
VIN = VCC or GND
II/O = 0,
VIN = 2.6 V
VIN = VCC or GND
VI/O = 3.3 V or 0,
VI/O = 3.3 V or 0,
VI = 0.4,
VI = 0.4,
VI = 0 V or 1 V,
Switch ON or OFF
Switch OFF
Switch ON
IO = â8 mA
IO = â8 mA
IO = â8 mA
â1.2 V
±1 μA
±1 μA
±2 μA
1 μA
10 μA
1
pF
2
pF
7.5
pF
6
10 â¦
0.35
â¦
2
â¦
(1) VIN and IIN refer to control inputs. VI, VO, II, and IO refer to data pins.
(2) All typical values are at VCC = 3.3 V (unless otherwise noted), TA = 25°C.
(3) For I/O ports, the parameter IOZ includes the input leakage current.
(4) This is the increase in supply current for each input that is at the specified TTL voltage level, rather than VCC or GND.
(5) Measured by the voltage drop between the A and B terminals at the indicated current through the switch. ON-state resistance is
determined by the lower of the voltages of the two (A or B) terminals.
4
Submit Documentation Feedback
Product Folder Links: TS3USB30E
Copyright © 2008â2012, Texas Instruments Incorporated
|
▷ |
German
Russian
Spanish
Italian
Polish
Chinese
Japanese
Korean
French
Portuguese