TS3USB30E_13 Datasheet, PDF (3/20 Pages) Texas Instruments – ESD PROTECTED, HIGH-SPEED USB 2.0 (480-Mbps) 1:2 MULTIPLEXER/DEMULTIPLEXER SWITCH WITH SINGLE ENABLE

TS3USB30E
www.ti.com
SCDS255E – DECEMBER 2008 – REVISED AUGUST 2012
ABSOLUTE MAXIMUM RATINGS^{(1) (2)}
over operating free-air temperature range (unless otherwise noted)
MIN
MAX UNIT
V_CC
Supply voltage range
V_IN
Control input voltage range⁽³⁾
V_I/O
Switch I/O voltage range^{(3) (4)}
I_IK
Control input clamp current
I_I/OK
I/O port clamp current
I_I/O
ON-state switch current⁽⁵⁾
Continuous current through V_CC or GND
T_stg
Storage temperature range
Dn+, Dn–
D+, D– when V_CC > 0
D+, D– when V_CC = 0
V_IN < 0
V_I/O < 0
–0.5
7
V
–0.5
7
V
–0.5 V_CC + 0.3
–0.5 V_CC + 0.3
V
–0.5
5.25
–50 mA
–50 mA
±64 mA
±100 mA
–65
150 °C
(1) Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) All voltages are with respect to ground, unless otherwise specified.
(3) The input and output voltage ratings may be exceeded if the input and output clamp-current ratings are observed.
(4) V_I and V_O are used to denote specific conditions for V_I/O.
(5) I_I and I_O are used to denote specific conditions for I_I/O.
PACKAGE THERMAL IMPEDANCE⁽¹⁾
θ_JA
Package thermal impedance
DGS package
RSW package
TYP UNIT
56.5
°C/W
175
(1) The package thermal impedance is calculated in accordance with JESD 51-7.
RECOMMENDED OPERATING CONDITIONS⁽¹⁾
V_CC
Supply voltage
V_IH
High-level control input voltage
V_IL
Low-level control input voltage
V_I/O
Data input/output voltage
T_A
Operating free-air temperature
V_CC = 3 V to 3.6 V
V_CC = 4.3 V
V_CC = 3 V to 3.6 V
V_CC = 4.3 V
MIN
MAX UNIT
3
4.3 V
1.3
V
1.7
0.5
V
0.7
0
V_CC
V
–40
85 °C
(1) All unused control inputs of the device must be held at V_CC or GND to ensure proper device operation. Refer to the TI application report,
Implications of Slow or Floating CMOS Inputs, literature number SCBA004.
Copyright © 2008–2012, Texas Instruments Incorporated
Product Folder Links: TS3USB30E
Submit Documentation Feedback
3