DRV8816PWPR Datasheet, PDF (4/17 Pages) Texas Instruments – DMOS DUAL ½-H-BRIDGE MOTOR DRIVERS

DRV8816
SLRS063 – SEPTEMBER 2013
EXTERNAL COMPONENTS
Component
Pin 1
Pin 2
Recommended
C_VBB1
C_VBB1
C_VCP
R_nFAULT
R_SENSE
VBB
VBB
VCP
VCC ⁽¹⁾
SENSE
GND
GND
VBB
nFAULT
GND
0.1 µF capacitor rated for VBB
100 µF capacitor rated for VBB
16 V, 0.1 µF ceramic capacitor
> 1 kΩ
Optional low-side sense resistor connected to shunt
(1) VCC is not a pin on the DRV8816, but a VCC supply voltage pullup is required for open-drain output nFAULT
www.ti.com
ABSOLUTE MAXIMUM RATINGS⁽¹⁾
over operating free-air temperature range (unless otherwise noted)
VBB
VDD
V_Sense
T_A
T_j
T_stg
Load supply voltage
Charge Pump Voltage (VCP, CP+)
Charge pump negative switching pin range (CP-)
Digital pin voltage range (IN1, IN2, EN1, EN2, nSLEEP, nFAULT)
VBB to OUTx
OUTx to SENSE
Sense voltage (SENSE)
H-bridge output current (OUT1, OUT2, SENSE)
VPROPI pin voltage range (VPROPI)
Operating ambient temperature
Operating junction temperature
Storage temperature range
MIN
MAX
UNIT
-0.6
40
V
-0.6
VBB + 7
V
-0.6
VBB
V
–0.3
7
V
-0.6
40
V
-0.6
40
V
-0.5
1.0
v
0
2.8
A
-0.3
3.6
V
-40
85
-40
190
°C
-40
125
(1) Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under “recommended operating
conditions” is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
HBM on any other pin
Charge Device Model (CDM)
ELECTROSTATIC DISCHARGE PROTECTION
MIN
2000
500
MAX
UNIT
V
4
Submit Documentation Feedback
Product Folder Links: DRV8816
Copyright © 2013, Texas Instruments Incorporated