AMC1204_14 Datasheet, PDF (4/37 Pages) Texas Instruments – 20MHz, Second-Order, Isolated Delta-Sigma Modulator for Current-Shunt Measurement

AMC1204
AMC1204B
SBAS512D – APRIL 2011 – REVISED DECEMBER 2013
ISOLATION CHARACTERISTICS
PARAMETER
TEST CONDITIONS
V_IORM
Maximum working insulation voltage
per IEC
V_PD(t)
Partial discharge test voltage per
IEC
t = 1s (100% production test),
partial discharge < 5pC
V_IOTM
Transient overvoltage
t = 60s (qualification test)
t = 1s (100% production test)
R_S
Isolation resistance
PD
Pollution degree
V_IO = 500V at T_S
www.ti.com
AMC1204
1200
AMC1204B
1200
2250
4000
4800
> 10⁹
2
2250
4250
5100
> 10⁹
2
UNIT
V_PEAK
V_PEAK
V_PEAK
V_PEAK
Ω
Degrees
ISOLATOR CHARACTERISTICS⁽¹⁾
PARAMETER
TEST CONDITIONS
MIN
TYP
MAX UNIT
L(I01) Minimum air gap (clearance)
Shortest terminal to terminal
distance through air
DWV package
DW package
8
7.9
mm
mm
L(I02)
Minimum external tracking
(creepage)
Shortest terminal to terminal
distance across the package
surface
DWV package
DW package
8
7.9
mm
mm
CTI
Tracking resistance
(comparative tracking index)
DIN IEC 60112/VDE 0303 part 1
> 400
V
Minimum internal gap
(internal clearance)
Distance through the insulation
0.014
mm
R_IO Isolation resistance
C_IO
Barrier capacitance input to
output
Input to output, V_IO = 500V, all pins on each side of
the barrier tied together to create a two-terminal
device, T_A < +85°C
Input to output, V_IO = 500V,
+100°C ≤ T_A < T_A max
V_I = 0.8V_PP at 1MHz
> 10¹²
Ω
> 10¹¹
Ω
1.2
pF
C_I
Input capacitance to ground V_I = 0.8V_PP at 1MHz
3
pF
(1) Creepage and clearance requirements should be applied according to the specific equipment isolation standards of a specific
application. Care should be taken to maintain the creepage and clearance distance of the board design to ensure that the mounting
pads of the isolator on the printed circuit board (PCB) do not reduce this distance. Creepage and clearance on a PCB become equal
according to the measurement techniques shown in the Isolation Glossary section. Techniques such as inserting grooves and/or ribs on
the PCB are used to help increase these specifications.
4
Submit Documentation Feedback
Copyright © 2011–2013, Texas Instruments Incorporated
Product Folder Links: AMC1204 AMC1204B