English
Language : 

XPC8255ZUIFBC Datasheet, PDF (36/41 Pages) Texas Instruments – PowerQUICC II Integrated Communications Processor Hardware Specifications
Pinout
Table 14. Pinout List (continued)
Pin Name
Ball
VCCSYN1
B9
GNDSYN
SPARE13
SPARE43
SPARE54
SPARE63
THERMAL05
THERMAL15
AB1
AE11
U5
AF25
V4
AA1
AG4
I/O power
AG21, AG14, AG8, AJ1, AJ2, AH1,
AH2, AG3, AF4, AE5, AC27, Y27,
T27, P27, K26, G27, AE25, AF26,
AG27, AH28, AH29, AJ28, AJ29, C7,
C14, C16, C20, C23, E10, A28, A29,
B28, B29, C27, D26, E25, H3, M4,
T3, AA4, A1, A2, B1, B2, C3, D4, E5
Core Power
U28, U29, K28, K29, A9, A19, B19,
M1, M2, Y1, Y2, AC1, AC2, AH19,
AJ19, AH10, AJ10, AJ5
Ground
AA5, AF21, AF14, AF8, AE7, AF11,
AE17, AE23, AC26, AB25, Y26, V25,
T26, R25, P26, M25, K27, H25, G26,
D7, D10, D14, D16, D20, D23, C9,
E11, E13, E15, E19, E22, B3, G5,
H4, K5, M3, P5, T4, Y5, AA2, AC3
Note:
1 Only on Rev C.2 silicon.
2 The default configuration of the CPM pins (PA[0–31], PB[4–31], PC[0–31], PD[4–31]) is input. To prevent excessive DC current,
it is recommended to either pull unused pins to GND or VDDH, or to configure them as outputs.
3 Must be pulled down or left floating.
4 Must be pulled down or left floating. However, if compatibility with HiP4 silicon is required, this pin must be pulled up or left
floating.
5 For information on how to use this pin, refer to MPC8260 PowerQUICC II Thermal Resistor Guide available at
www.freescale.com.
Symbols used in Table 14 are described in Table 15.
Table 15. Symbol Legend
OVERBAR
UTM
Symbol
Meaning
Signals with overbars, such as TA, are active low
Indicates that a signal is part of the UTOPIA master interface
MPC8260 PowerQUICC II Integrated Communications Processor Hardware Specifications, Rev. 2
36
Freescale Semiconductor